Advertisement
Video Transmitter 5.8G VTX-mini
QUICK START GUIDE
40CH(A/B/E/F/R Band), E4 & E8 are disabled by default.
Any Frequency/band can be disabled or enabled by CLI command
Variable Output Power: PIT, 25, 200, 400, 800mW
Button control and LED indicators
Cms Control(Tramp protocol) via FC Uart _Tx
Switchable VTX input power via FC PINIO
Constant full frequency band power
Clean powerup and frequency switching
Built-in microphone
Upgradeable firmware
Convertible 20 to 30mm mounting
Input voltage: 6~36V(2~8S LiPo)
5V Output: 1A for Camera or FC
Power Consumption: 3.5W@ 800mW
Video Input Impedance: 75 Ohm
Audio Subcarrier Frequency: 6.5 MHz
RF Connector: MMCX
Video Format: NTSC/PAL
Weight: 4.5g (VTX-mini only, w/o antanna)
Size1: 28*28*4mm w/20mm_Φ3mm mounting
Size2: 36*36*5mm w/30.5mm_Φ3mm mounting
Includes
1x 5.8G Video transmitter VTX-mini
1x MMCX 5.8G whip antenna, 8cm
1x 20mm to 30.5mm conversion plate
Aug.2019 Rev 1.0
www.mateksys.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Mateksys Video Transmitter 5.8G VTX-mini
- Page 1 Video Transmitter 5.8G VTX-mini QUICK START GUIDE 40CH(A/B/E/F/R Band), E4 & E8 are disabled by default. Any Frequency/band can be disabled or enabled by CLI command Variable Output Power: PIT, 25, 200, 400, 800mW Button control and LED indicators CMS control(Tramp protocol) via FC Uart _Tx...
- Page 2 New Frequency & Power will be saved if no button action within 5 seconds. The VTX remains the current frequency until new setting is saved. PIT mode: Press B to enter PIT mode(1mw output), Pit LED blinks Press B again to quit PIT mode Aug.2019 Rev 1.0 www.mateksys.com...
- Page 3 Allowed values: OFF, ON, UNTIL_FIRST_ARM If ON and the flight controller is disarmed, the video transmitter output power will be set to 25mw Otherwise, the video transmitter output power will be set to the configured value. Aug.2019 Rev 1.0 www.mateksys.com...
- Page 4 E8 9. You can also enable/disable whole band e.g. “set band A = disable” 10. If Freq/band is disabled, button control will jump over it. 11. Unplug USB & battery, Serialpassthrough mode will be invalid. Aug.2019 Rev 1.0 www.mateksys.com...
Need help?
Do you have a question about the Video Transmitter 5.8G VTX-mini and is the answer not in the manual?
Questions and answers