ENGLISH SINBO SSI 6625 GARMENT STEAMER INSTRUCTION MANUAL Please read these instructions for use and have a good look at the illustration before using the appliance SAFETY INSTRUCTIONS When using electrical appliances, basic safety precautions should always be followed. • Do not place the product too close to any heat emitting appliances or in direct sunlight.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Page 4
INSTRUCTION FOR USE Filling the Water Tank • Ensure the appliance is unplugged from the mains power supply. • Place the Steamer on a flat, stable surface. • Carefully unscrew and remove the water tank cap. • Fill the water tank with water using the supplied measuring cup. •...
Steaming Garments • Place the garment on a clean rust-free hanger. • Direct the steam nozzle towards the bottom of the garment. • Steam will rise on both the inside and the outside of the fabric removing the wrinkles and creases. Slowly slide the steam nozzle upwards from the bottom to the top of the garment.
SPECIFICATION Unit Weight (Bare) : 0.7kg Capacity : 150ml Steam Output Time : 2 minutes Steam Duration : 14 minutes Voltage : AC230V, 50/60Hz Power : 800W TROUBLESHOOTING Problem Possible Reasons Solution Unit fails to heat Unit is not plugged in Plug into mains power supply Switch is not activated Press the On/Off switch...
Need help?
Do you have a question about the SSI 6625 and is the answer not in the manual?
Questions and answers