AlbaChem Alba-STEAM Instruction Manual

Advertisement

INSTRUCTION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Alba-STEAM and is the answer not in the manual?

Questions and answers

Summary of Contents for AlbaChem Alba-STEAM

  • Page 1 INSTRUCTION MANUAL...
  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE READ ALL INSTRUCTIONS BEFORE USE When using your steam station, basic safety precautions should always be followed. Please read the following instructions carefully as they provide important infor-mation concerning how to install, use and care for this product.
  • Page 3: Technical Data

    LIGHT COMMERCIAL USE ONLY FEATURES • Low water light indicator • Auto shut-off thermostat protection • Regular tap water or 50/50 tap/distilled water • 50 p.s.i operating pressure • Ceramic terminal block • 12-gauge heavy-duty wiring • Up to 4 hours of steam IMPORTANT: When you want to dispose of the appliance, NEVER throw it in the garbage.
  • Page 4: How To Assemble And Use

    HOW TO ASSEMBLE AND USE Remove the steam station from its packing and make sure all packing has been removed (including the protective bags). Put the station on a flat and solid surface. Insert the wan into the flange on top of the boiler, tighten with the side screw.
  • Page 5 The boiler must be cleaned periodically and any sediment/mineral buildup removed from inside the unit; otherwise, it may become clogged. The period between cleanings depends on the frequency of use and the quality/hardness of the water used. If the unit is in daily use with regular municipal tap water, we recommend a cleaning every two weeks to a month.
  • Page 6 DESCRIPTION OF THE 1. Safety cap 2. Pressure gauge (manometer) 3. Steam button 4. Boiler button 5. Low water light indicator 6. Steam regulating knob 7. Cord support 8. Steam switch 9. Steam gun 10. Thermostat reset button 1700DA...
  • Page 7: Troubleshooting

    TROUBLESHOOTING PROBLEM POSSIBLE CAUSES REMEDY 1. While filling the tank you 1. The problem will go on The steam is too wet. may have poured too until the excess water is much water into it. emptied. Keep the steam button pressed until the water in the tank is at the correct level.
  • Page 8 PRODUCTS WARRANTY warrants to original purchaser of its products that every product sold by is free from defects in material and workmanship for a period of one year from the date of purchase if properly used and maintained. Subject to the conditions and limitations set forth below, will either repair or replace any part of a Product that proves defective by reason of improper workmanship or materials.

Table of Contents