CORNER THROUGH WALL INSTALLATION
3" (7.5 cm)
HORIZONTAL EXHAUST
THROUGH WALL INSTALLATION
A chimney connector shall not pass through an attic or roof space, closet
or similar concealed spaces, or a fl oor, or ceiling. Where passage through
a wall or partition of combustible construction is desired, the installation
shall conform to CAN/CSA-B365 Installation Code for Solid-Fuel-Burning
Appliances and Equipment. Only use venting of L or PL type with an inside
diameter of 3 or 4 inches (7.6 or 10.1 cm).
Exhaust Tube
Fresh Air Intake
High Temperature RTV
Silicone Required
March 2008 Product Specifi cations Book
Gas Inbuilt
Fresh Air Intake
Wall thimble
manufactured
by pellet vent
manufacturer.
3"
(7.5 cm)
3" (75mm) or 4" (100mm)
"PL" or "L" vent
Wall Thimble
45° Elbow with screen
or Termination Cap
VERTICAL RISE WITH HORIZONTAL
TERMINATION INSTALLATION
A 45° elbow with a rodent screen may be used in place of the termination
cap (or stainless steel termination hood).
THROUGH CONCRETE WALL
WITH VERTICAL RISE INSTALLATION
A 45° elbow with a rodent screen may be used in place of the termination
cap (or stainless steel termination hood).
This is the recommended installation to use if there is a concrete or retain-
ing wall in line with exhaust vent on pellet stove.
The termination must be 12 inches (30 cm) from the outside wall and 12
inches (30 cm) above the ground.
GF55 Wood Pellet Stove
5