Camera Position - Telefunken TF-DVR12HD Instruction Manual

4. HDMI port
5. TFT rotating screen
Rear panel
7 8
6
6. PWR button
7. M button
8. Cursor/OK button
9. MENU button
Top panel
11 12
10
10. Mic
11. RESET hole (button)
12. Stand fixing holes
13. Speaker
Operations
Mounting
• Insert the fixing pins on the top of the
stand into the bracket holding holes in the
bottom of the unit and move the unit backward
until a click to fix it tightly to the bracket.
• Press the suction cup to a surface in the
car, then push the pressure valve down. Make
sure the stand is fixed properly to the surface.
loosening the upper and lower washers and
bending the assembly knots.
valve, then lift the plastic ear on the suction cap.
you can rotate the display in one plane relative to
the hinge axis 270
9
by rotating it manually at the angle of ±85
select the best recording view angle.
its USB port to the PC with the suppled USB
cable; or connect it to a car lighter socket
with the suppled car adapter. The power icon
indicates the remaining battery power. During
charging from PC the unit can function only as
PC camera.
memory card into the memory card slot of this
unit until a click. Insert the card with correct side.
13
For correct and satisfactory operation, licensed
memory cards of famous brands should be
used with this unit. Avoid using memory cards
of unknown brands. The performance class of
the card should be 6 or above, otherwise the
video quality may be low resulting in uneven
video playback.
to car power source, recording will be started
automatically. After you disconnect the power
source, the unit will stop recording and save
the recorded information.
to switch on the unit (press and hold it again
if you want to switch off the unit). Select
recording mode by pressing repeatedly MODE
Instruction manual
• You can adjust the angle of the stand by
• To unmount the stand, lift the pressure
Rotary display
To improve the display angle for viewing it,
rightwards.
0

Camera position

You can adjust the vertical camera position
Power and charging
To charge the battery of this unit connect
on the bottom right corner of the display
Recording
• Before you start recording, insert an SD
SD capacity supported: up to 32 GB.
• Auto recording: After you connect this unit
• Manual recording: Press PWR button
to
0
3