Erbauer EBC18-Li Original Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

EBC18-Li

EAN. 3663602418238

ORIGINAL INSTRUCTIONS

Table of Contents

Need help?

Do you have a question about the EBC18-Li and is the answer not in the manual?

Questions and answers

Summary of Contents for Erbauer EBC18-Li

Page 1 EBC18-Li EAN. 3663602418238 ORIGINAL INSTRUCTIONS...
Page 2: Product Description
Product description WARNING! Please read all safety warnings carefully and be sure Safety instructions that they are fully understood before handling the tool. Assembly Care & maintenance PRODUCT DESCRIPTION Battery pack release button* 16. Release button of trimmer head Power bar button* 17.
Page 3 PRODUCT DESCRIPTION 13 14 20 21 23 24...
Page 4 max. ② ①...
Page 5: Safety Instructions
SAFETY INSTRUCTIONS 11 cm GENERAL POWER TOOL SAFETY WARNINGS WARNING! Read all safety warnings, instructions, illustrations and specifications provided with this power tool. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future 12 cm reference.
Page 6: Personal Safety
c. Do n ot expose power tools to rain or wet conditions. Water f. Dre ss properly. Do not wear loose clothing or jewellery. Keep entering a power tool will increase the risk of electric shock. your hair, clothing and gloves away from moving parts. Loose clothes, jewellery or longhair can be caught in moving parts.
Page 7 f. K eep cutting tools sharp and clean. Properly maintained Do not expose a battery pack or tool to fire or excessive cutting tools with sharp cutting edges are less likely to bind and temperature. Exposure to fire or temperature above 130 °C are easier to control.
Page 8: Operation
b. Never allow children, persons with reduced physical, sensory g. Before using the product and after any impact or dropping, or mental capabilities or lack of experience and knowledge or check for signs of wear or damage and repair as necessary. people unfamiliar with these instructions to use the machine, h.
Page 9: Maintenance And Storage
have come to a complete stop. e. Do not use loose rings or sleeves to «make up» bore sizes on brush cutter blades. s. Do not use the machine when the operator is tired, ill or under the influence of alcohol or other drugs. f.
Page 10: Vibration And Noise Reduction
i. If you intend to store a battery for a period without use then store b. Switch off and disconnect from the power supply if there battery at room temperature (19°C to 25°C), charged to about aremalfunctions. Have the garden power tool checked by 30 –...
Page 11 Trimmer guard ASSEMBLY Use the same method to attach the trimmer guard (18) as above.Then attach the cover on the trimmer guard (18) with other two screws (Fig. C2). WARNING! Never use the product without properly fitted guard! UNPACKING Unpack all parts and lay them on a flat, stable surface. WARNING! For all work with the machine, a correct protection guard (for •...
Page 12: Intended Use
Harness also assists the user when in use, supporting and holding the product. Put the harness (26) on your body and insert the two parts of the strap buckle (26a) into each other until a click is heard (Fig. F1). Adjust the length of the harness so that the hook is approximately 15cm below your waist.
Page 13: Using The Machine
USING THE MACHINE NOTE: Pay special attention when performing the work close to trees and bushes. The trimming head could damage sensitive bark, and damage WARNING! Never operate the tool without the guard and bike handle (7) fence posts. firmly in place. Failure to comply could result in possible serious personal injury.
Page 14 OVERLOAD, TEMPERATURE AND CHARGING PROBLEM WARNING! Improper use of a blade may cause it to crack, chip, or PROBLEM TOOL / BATTERY POSSIBLE SOLUTION shatter. Thrown parts may seriously injure the operator or bystander. STATUS CAUSE To reduce the risk of personal injury, it is essential to take the following Overload Product suddenly Extremely high...
Page 15: Care And Maintenance
NYLON LINE REWIND Take out approximately 5m of new nylon cutting line with a diameter of 2.0mm. CARE & MAINTENANCE Form a loop at the middle of the line and insert this loop into the hook on the spool, with one end of the line extending about 110 mm more than the other (Fig.
Page 16: Recycling And Disposal
• Secure the product to prevent it from slipping or falling over. STORAGE At Erbauer we take special care to select high quality materials and use manufacturing • Switch the product off and remove the battery pack. techniques that allow us to create ranges of products incorporating design and durability.
Page 17: Technical Specifications
For use with battery pack and charger as below: Battery pack model: EBAT18-Li-2 / EBAT18-Li-4 / EBAT18-Li-5 (sold separately) RATING LABEL EXPLANATION Charger model: EC18-Li / EFC18-Li / EMC18-Li (sold separately) EBC18-Li = MODEL NUMBER E = ERBAUER Sound level Brush Cutter...
Page 18 Ampere /min per minute Maximum rotational frequency of the spindle in /min Millimetre Kilogram Beware of blade thrust! This unit is not intended for use with a toothed type blade.Do not use dB(A) Decibel (A-rated) Metres per seccond aquared toothed blade! Manufacturing date code;...
Page 19: Declaration Of Conformity
London W2 6PX United Kingdom Declare that the product: Erbauer 18V Li-Ion brush cutter and grass trimmer EBC18-Li Serial number: from 000001 to 999999 Complies with the essential health and safety requirements of the following directives: 2006/42/EC The Machinery Directive...
Page 21 Manufacturer • Fabricant • Producent • Hersteller • Producator • Fabricante: Kingfisher International Products Limited 3 Sheldon Square London W2 6PX United Kingdom www.kingfisher.com/products DISTRIBUTOR: B&Q plc, Chandlers Ford, Hants, SO53 3LE United Kingdom www.diy.com Screwfix Direct Limited, Trade House, Mead Avenue, Yeovil, BA22 8RT, United Kingdom www.screwfix.com...