Page 5
NameLessRC N47 FPV Racing Drone Binding DSM receiver: 1. Connet the receiver to FC and run the BF.Choose the correct port and type of your receiver on the flight controller. 2. Type: set spektrum_sat_bind=9 in CLI then type ' save'.
Page 6
NameLessRC N47 FPV Racing Drone FRSKY receiver: 1. Select D8 mode on Frsky remote control. Hold the bind key on Frsky-Nano receiver and connect the battery, then the receiver's red light will be always on. 2. Select the BIND mode on remote control , the Frsky-Nano receiver's blue light will flash slowly and the red light will be always on which means bind complete.
Page 7
NameLessRC N47 FPV Racing Drone FLYSKY receiver: 1. Press and hold the key on the receiver and connect the power to the receiver. The green indicator light on the receiver indicates that the frequency is entered. 2, the remote control into the frequency of the state; the frequency into the receiver status indicator from the rapid flash to slow flash.
NameLessRC N47 FPV Racing Drone Frequency and power control methods: -The NLRC Nano400 VTX is set up via BFOSD Control (IRC Tramp) -The NLRC Nano400 VTX’s default set up is lock on 25mw. -To lock/unlock the VTX channels, please enter the PIT mode for three times within 30secs after powering up the VTX (PIT mode switch is set in BF mode page).
Page 9
NameLessRC N47 FPV Racing Drone Frequency Table(Mhz): Red area on frequency table is locked area! Please follow your local laws and regulations . Channel Band A 5865 5845 5825 5805 5785 5765 5745 5725 Band B 5733 5752 5771 5790...