Rear Panel Features - Sunfire TGR-401-230 User Manual

CHAPTER 1
Rear Panel Fea tures
3 4
2
1
9
1. AM Antenna
These con nec tions are for the
supplied AM loop antenna.
2. FM Antenna
The supplied FM antenna ¿ ts this
"F-type" coaxial connector. Other
antennas can be ¿ tted for im-
proved re cep tion.
3. SIRIUS Connection
This connection is provided for
the optional SIRIUS tuner kit
(SC-H1P1). This consists of an
antenna for picking up satellite ra-
dio transmissions, and a tuner unit
that connects here. The connec-
tion allows left and right audio and
control data to enter the TGR-401.
The OSD menus of the TGR-401
allow you to select your favorite
SIRIUS Satellite radio stations as
presets for easy recall. See page
63 for more details.
4. Audio/Video
These audio, composite-video
and S-video inputs con nect to the
outputs of your audio video com-
po nents. When these inputs are
selected, the audio will be heard
in your system, and the video will
be seen on the TV screen.
12
5 6
10 11 12 13
Fixed audio output is available, for
example for stereo recording to
a tape player, independent of the
TGR-401 volume. A stereo audio
Zone 2 output is also available.
S-Video and composite video out-
puts are available for monitoring,
as well as a composite video out-
put for Zone 2. Note that the video
sources you would like to play
in Zone 2 must use composite
video. (There is no video up/down
conversion in Zone 2.)
5. Component Video
These inputs con nect to the
component-video outputs of your
video sources if they have this
capability. When these inputs are
se lect ed, the TGR-401 will au to -
mat i cal ly route any video signals
going into these jacks to the com-
ponent video outputs. Note that
component video provides the
best picture compared to compos-
ite or S-video.
If your TV Monitor has component
video inputs, connect them to the
TGR-401's component outputs.
The TGR-401 can also up-convert
composite video and S-video from
the other inputs.
7
14 15 16
6. HDMI
Use these to connect any HDMI
components you may have in your
system. Three are inputs, and
one is an output to your HDMI-
equipped TV. This supports 1080p
and HDMIv1.3a sources. No on-
screen-display or audio decoding
inside the TGR-401 is available
from the HDMI inputs. Always
connect a separate digital audio
input cable when using HDMI.
7. Preamp Outputs
These line-level audio outputs
allow you to use external ampli-
¿ ers to power your loudspeakers.
There are outputs for L, R, C,
LS1, RS1, LS2, RS2, LB, RB, and
SUB.
8. Speaker-level Outputs
These speaker-level audio out-
puts connect to the input posts of
your loudspeakers.
9. 8-CH Inputs
These analog audio inputs can
connect to the output of an ex-
ternal surround processor, or a
source component such as DVD-
Audio, SACD, or a DVD player
8
17 18
User's Manual