Download Print this page

Lumi-O Innovaplas 9010 Instructions

Innovalite solar powered light

Hide thumbs

INNOVALITE SOLAR POWERED LIGHT # 9010

WARNING

Risk of drowning by entangle-

ment; secure the power cord

with tie wrap supplied as per

instructions.

TABLE OF CONTENTS

A) Light installation on the step

B) Deck installation

C) Step combo Installation

D) User guide

E) Winterizing

CAUTION

The lighting fixture may be damaged if subjected to freezing weather.

Remove the entire step assembly from the pool and allow all water to

drain from the step and dry before storing.

Store in a dry location unexposed to winter conditions.

Do not submerge the solar panel the product could be damaged.

OOLS REQUIRED

For Biltmor and Aquarius only.

REV. 15/04/2019

1) Remove the Innovaplas round cap from the step by compressing 2 tabs at the back.

For the Biltmor or Aquarius step cut the 4 tabs with a utility knife to remove the blank

cap.

2) Insert the lighting fixture from the outside of the step.

3) Fasten the treaded ring and align the fixture properly in the step before tightening.

Tighten the ring moderately.

IMPORTANT: Use supplied tie wraps to attach electric cord to a post as

(Not Included)

REQUIRED FOR SKU # 9010

LIGHT INSTALLATION ON THE STEP

shown. Do not submerge the connector the product could

be damaged.

COMPATIBLE WITH ANY INNOVAPLAS STEP

CONTAINING THE INNOVAPLAS CREST ROUNDEL

Utility knife

x 2

Water tight IP68 connectors

LIMITED WARRANTY

90 days on manufacturing defects.

Replacement only.

For Biltmor

or Aquarius

step.

Treaded ring

Pool step

Table of Contents

Need help?

Do you have a question about the Innovaplas 9010 and is the answer not in the manual?

Questions and answers

Summary of Contents for Lumi-O Innovaplas 9010

Page 1 INNOVALITE SOLAR POWERED LIGHT # 9010 WARNING LIGHT INSTALLATION ON THE STEP Risk of drowning by entangle- For Biltmor ment; secure the power cord or Aquarius with tie wrap supplied as per step. instructions. Utility knife 1) Remove the Innovaplas round cap from the step by compressing 2 tabs at the back. TABLE OF CONTENTS For the Biltmor or Aquarius step cut the 4 tabs with a utility knife to remove the blank cap.
Page 2 DECK INSTALLATION* Connection of cable Step A 1) Identify the best location to install the solar panel. The panel should be pointing toward the sun at noon. Avoid major obstacles between the sun and the panel. The panel should be exposed to a light source for a minimum duration of 6 hours to perform.