Our liability will be no more than the amount you paid for the product that is the subject of a claim. This is the maximum amount for which we are responsible. Newton Waterproofing Systems reserve the right to change the product specification at any time.
NOTE: This is a waterproofing detail. For the design of the structure, please use a professional designer. We strongly recommend that Newton waterproofing systems are installed by our NSBC registered contractors who will guarantee, insure and accept liability for both the design and the installation of our systems. Please refer to product data sheets before installation of our products. Newton Waterproofing Systems reserves the right to update drawings.
Newton Titan-Pro couplings - 50mm external. pumping system with 2 x Newton Manual pumps INSTALLATION POSITIONING The Inverter/Charger units are mains powered and should be installed by persons who are electrically competent NOTE: ALL POWER INVERTERS NEED TO BE INSTALLED INTERNALLY IN A DRY AND WELL VENTILATED SPACE by way of appropriate training to either fit a fused plug or wire directly to a fused spur.
6. Remove the right (AC OUT) wiring block from the base of the inverter 7. Wire AC OUT with correctly rated mains cable from either a Newton automatic pump, or from the ‘pump 2’ connection of the CP2, CP7 or CP9 control panel 8.
• Standard settings: ready for use charger On delivery, the MultiPlus Compact is set to standard factory values ready for use as part of a Newton Pumping charger only alarm System with charging voltages set for the three batteries, supplied by Newton Waterproofing Systems for use within power supplies of 230V input voltage and 50Hz frequency.
TROUBLESHOOTING The following table provides a quick reference of the more common faults. Disconnect the battery/batteries pumping systems before diagnosing the fault. Consult Newton Waterproofing Systems if the fault cannot be resolved. Problem Cause Solution The inverter fails to Processor in ‘no function mode’...