1.2 Installation Follow the steps below: 1. In most cases it is recommended to set the device’s IP address prior to installation. See W5-JEM1 User Manual for complete instructions. a. Note: factory default IP address is 192.168.1.10 for all units 2.
LED State Network Status Meaning No Power W5-JEM1 has no power Flashing Green Online, not connected W5-JEM1 is online but is not connected to a PLC. Green Online, connected W5-JEM1 is operating normally and is connected to a PLC Flashing Red Connection time-out One or more connections are timed out.
Western Reserve Controls W5-JEM1 Wiring & Installation Revision 1.0 1.6 Product Drawing and Dimensions Shown below are the overall dimensions of the product when installed on a piece of standard DIN rail. This drawing does not include the overall height or length added by the Power, Serial, or Ethernet cables or their respective connectors.
Western Reserve Controls W5-JEM1 Wiring & Installation Revision 1.0 1.8 Serial Wiring Diagrams The serial port can be operated as RS-232, RS-422, or RS-485 connection. Selection between RS-232, 422 or 485 is made by using the correct cable for the desired RS specification.
Page 7
Western Reserve Controls W5-JEM1 Wiring & Installation Revision 1.0 Figure 6. RS-422 Wiring Diagram Figure 7. RS-485 Wiring Diagram 1.9 Models and Part Numbers WRC Order Number Description W5-JEM1-DH2 DIN Mount Serial to EtherNet/IP Gateway END OF DOCUMENT PUB005-20190314-A01...
Need help?
Do you have a question about the W5-JEM1 and is the answer not in the manual?
Questions and answers