Page 2
EAGLETONE E-TOUCH ELECTRONIC DRUMS EAGLETONE ELECTRONIC DRUMS VDS500 User’s manual english User’s manual english PRECAUTION Congratulations! and dirt. Thank you for purchasing this digital drum set. The drum set • Never use cleaners such as alcohol or thinner. has been Developed to act and play like a drum set but with •...
User’s manual english EAGLETONE E-TOUCH ELECTRONIC DRUMS CONTENTS CONTENTS 6. Record and replay ............20 Record quickly ................20 1. Assembly instrucions ............1 Play the recorded song..............20 Inside this package ................1 7. Set up ................20 Packing information...............2 Trigger sensitivity .................20 2.
EAGLETONE E-TOUCH ELECTRONIC DRUMS User’s manual english ASSEMBLY INSTRUCTIONS 1. ASSEMBLY INSTRUCTIONS Caution! Watch your fingers when adjusting clamps, they may become pinched resulting in injury. Be careful around pipe ends, inside the pipe and screw ends, metal shavings, etc. May injure your fingers.
EAGLETONE E-TOUCH ELECTRONIC DRUMS User’s manual english CONNECTORS / GETTING READY TO PLAY THE DRUMS 2. ASSEMBLY Caution • While adjusting the collar, please take extra care to avoid injury. • Set the each part to the correct position. Assembly steps: Drum stand assembly 1.
User’s manual english EAGLETONE E-TOUCH ELECTRONIC DRUMS GETTING READY TO PLAY THE DRUMS 20. Set the module stand to proper position. 21. Screw down. 22. Adjust the balance of the drum stand. 23. Tighten all the screws at the collars. Tighten the clip screw.
EAGLETONE E-TOUCH ELECTRONIC DRUMS User’s manual english GETTING READY TO PLAY THE DRUMS Assemble the pedal and the bass drum 1. Put the pedal to the left floor. 2. Put the bass drum (with hammer) to the right floor. 5. Fix the support bar to the pedal.
User’s manual english EAGLETONE E-TOUCH ELECTRONIC DRUMS GETTING READY TO PLAY THE DRUMS Connect the pads 1. Use the cable to connect the D-SUB connector of the module and the pad. 2. Use the cable tie to tie the cable ( 12 ties)
EAGLETONE E-TOUCH ELECTRONIC DRUMS User’s manual english GETTING READY TO PLAY THE DRUMS 3. MODULE FUNCTION Rear panel Front panel 21 22 17 DC-IN Power adaptor connector, 9V DC 18 MIDI IN/OUT PORT Connects with external MIDI devices (The drum MIDI signal outputs via MIDI OUT to external audio source.
User’s manual english EAGLETONE E-TOUCH ELECTRONIC DRUMS GETTING READY TO PLAY THE DRUMS / FACTORY SETTINGS 4 CONNECT WITH EXTERNAL DEVICES Connect with MIDI keyboard MIDI port: connect with the MIDI OUT connector of MIDI Connecting with audio system or drum speaker cabinet keyboard or external pads as the external audio source to control this digital drum.
EAGLETONE E-TOUCH ELECTRONIC DRUMS User’s manual english VOICE LIST 2. Press [KIT REV ON/OFF] key to enter into drum selection. The display shows drum kit number and the KIT LED lights up. Use [-DATA+] button to select drum kit. Pad pan...
User’s manual english EAGLETONE E-TOUCH ELECTRONIC DRUMS DRUM KITS LIST / STYLE LIST shows the song number. SONG LED flashes once and then tion. If “DRUM OFF” starts, the drum sound will be closed and lights off. “DRUM OFF” LED lights on.
EAGLETONE E-TOUCH ELECTRONIC DRUMS User’s manual english MIDI IMPLEMENTATION CHART Note: the loudness. • During recording, the metronome function will not automa- • CURVE 1: Small dynamic response. Select this curve and it tically start. If user needs to start the metronome function, delivers high but stable volume.
User’s manual english EAGLETONE E-TOUCH ELECTRONIC DRUMS SPECIFICATIONS sound and it outputs the relative MIDI signal. When this function is turned off, the audio source module will not be controlled by the trigger directly, but will controlled by the MIDI input signal.
User’s manual english EAGLETONE E-TOUCH ELECTRONIC DRUMS 10. TROUBLE SHOOTING Problem ........Reason No sound ........Please confirm the volume knob is not turned off Pad has no sound ..... 1. confirm the pad connection is correct............2. confirm the pad volume is not set to 0 Metronome has no sound ..