Table of Contents
Advertisement
WOODBRIDGE
ELECTRONIC TOILET SEAT
Thank you for choosing our products.Please read the instructions carefully before
installation and keep it available for future maintenance or reference.
Our company reserves the right of final interpretation for this manual.
The manual is subject to change without notice.
B0940S
T-0008
Installation Manual
R
Advertisement
Table of Contents
Summary of Contents for Woodbridge B0940S
- Page 1 WOODBRIDGE ELECTRONIC TOILET SEAT B0940S T-0008 Installation Manual Thank you for choosing our products.Please read the instructions carefully before installation and keep it available for future maintenance or reference. Our company reserves the right of final interpretation for this manual.
-
Page 2: Table Of Contents
READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION. 2 PEOPLE ARE REQUIRED TO LIFT AND DURING ENTIRE INSTALLATION OF THIS PRODUCT INSTALLATION OF THIS PRODUCTS BY AN INEXPERIENCED INSTALLER MAY RESULT... -
Page 3: Important Safeguards
IMPORTANT SAFEGUARDS When using electrical products, especially when children are present, basic safety precautions shouldalways be followed, including the following: 1.The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction. - Page 4 IMPORTANT SAFETY INSTRUCTIONS CAUTION – Indicates that failure to follow the instruction may cause body injury or property damage. 1. Do not install or use the product in wet places as steam room etc.This product must be connected to properly grounded power outlet socket. 2.
-
Page 5: Technical Specification
echnical Specification Rating pressure AC 110-120V,50/60Hz Rating power 1050-1250W Main Unit Minimum water pressure 0.07MPa (20L/min. flowing pressure). Water pressure range Maximum water pressure 0.8MPa (Hydrostatic pressure) Electrical wire length is about 1.8m Container capacity 600 ml Heating power 100 0W Water 6 different level adjustment temperature... -
Page 6: List Of Packing
Packaging List Remote Control Panel Parts Base plate Base Plate Parts Water Supply Assembly Installtion Installtion Manual Manual Warranty Installtion Warranty Installation Warranty Card Card paperboard Manual Card Installation Installation paperboard paperboard Main Unit... -
Page 7: Parts Identification
Main unit identification Water inlet Water connector discharging cover Side receiving Main unit window disassembly button Main unit button Socket Remote control receiving window Power indicator Energy saving indicator Wand Seat Hole for rear cleaning Drying device Base plate Night light Hole for ladies’... -
Page 8: Installation Instructions
Installation lnstruction Installation dimension Note:please check if the installation dimension matching the user’s toilet. Installation of mounting plate Press the expansion nuts into the installation holes in the toilet,then install the base plate, plastic plates,flat washers and bolt as per the drawing and tighten the bolts. Bolt The black pin frontward and groove upwards. -
Page 9: Installation And Disassembly Of Main Unit
Installation and disassembly of main unit Disassembly Installation Press the “removal button” on washlet, Push the washlet back onto the base until a “click” is heard,and pull it out. plate until a “click” is heard. Installation Note: Before pulling out the washlet,release hand from Disassembly “removal button”. -
Page 10: Usage Instruction
Installation instruction Checking the power and water supply Connect the water supply hose and turn on the Insert power plug into power socket. angle valve.Check if any leakage. Indicator light Grounded Electric leakage test button outlet Water tank Protection switch Press protection switch... -
Page 11: Function Illustration Of Keys In Main Unit And Actuator
Function illustration of keys in main unit and actuator 1. Long press “Power” button to enter standby mode; and then quick press “Power” button to restore functional mode. 2. When people sit, press “Power” button to stop the Power function of rear, front cleaning or drying. When no one sits, press “Power”... -
Page 12: Daily Maintenance
Daily maintenance Main unit maintenance 1.Shut off power supply at maintenance. 2.Turn the seat upward open,press down the button located on the right side of main unit and pull out the seat.Wipe the stain with a soft damp cloth. 3.Afte cleaning re-install the seat back to main unit. -
Page 13: Inlet Filter Cleaning
Inlet filter cleaning 1.Pull out electrical plug,then shut off water supply valve and remove water supply hose. 2.Remove the filter.Use the brush to clean the filter. 3.Put the filter back into inlet after cleaning.Then connect the water supply pipe. Remove the filter. Use the brush to clean the filter. -
Page 14: Troubleshooting Guide
Troubleshooting Guide Problem Cause Solution Water supply hose buckling Solve the buckling causes block No flushing Turn on the fill valve Fill valve is off Connect water supply and Water supply is cut off wait for the water Water supply hose buckling Solve the buckling causes partial block Fill valve is not fully turned on... - Page 15 Please contact us if you have any questions. Customer Service Phone: 562-774-2284. Or email : help.woodbridge@gmail.com The picture of product may not entirely consistent with actual appearance and color because of products improvement, please in kind prevail.
Need help?
Do you have a question about the B0940S and is the answer not in the manual?
Questions and answers