Advertisement
Using your Reflexology Foot Spa
1. Ensure that the control dial is in the
'O' OFF position.
2. Place the product on a firm, level floor.
3. Place a chair behind the unit and adjust its
position until you can sit comfortably with
your feet inside the appliance (without water).
4. Place a towel within easy reach to dry your
feet afterwards.
5. Using a large jug, fill the foot massager
with water. Do not fill above the maximum
level indicated.
6. Do not use hot water as this will make your
feet sweat.
7. Insert the plug into a 230-240 volt power
outlet and turn on.
8. Sit in the chair and place your feet in the
appliance.
9. Turn the control dial to the setting you
wish to use -
Help Line
If you have any additional questions about using the Reflexology Foot Spa please call the
Sunbeam help line in Australia on 1 800 025 059. In New Zealand please call (09) 912 0747
6
Massage and Heat
To increase the intensity of the massage,
move your feet backwards and forwards
over the rollers in the base of the product.
If the rollers are not required simply remove
and replace with the plain insets. The water
will remain at an agreeable temperature.
Please note that the product will not heat
cold water but will simply help to prevent
warm water from going cold.
Bubble and Heat
Use the heat setting along with spa bubbles.
Massage, Heat and Bubble
Use all three settings together.
The removable Massage attachments can
be interchanged to give feet the desired
reflexology massage.
Please refer to the enclosed Guide
to Reflexology.
Hide quick links:
Advertisement
