Table of Contents
Advertisement
Quick Links
Quick Installation Guide
Contents Table
Contents Table ........................................................................................ 1
Chapter I Introduction .......................................................................... 2
1.1 Overview ............................................................................................................................. 2
1.2 Features ............................................................................................................................... 2
Chapter II Hardware setup ................................................................... 3
2.1 Interface & Indicator Light Introduction ............................................................................. 3
2.1.1 MODEM Indicator Light & Interface Introduction ............................................. 3
2.1.2 Interface of splitter ................................................................................................ 4
2.2 Package checking ................................................................................................................ 4
2.3 Layout ................................................................................................................................. 4
Chapter III Configuration Instructions ................................................ 5
3.1 Before Configuration: ......................................................................................................... 5
3.2 Instructions to Configure Router Through Web Interface ................................................... 5
For MS41p1
Advertisement
Table of Contents
Summary of Contents for Global411 MS41p1
-
Page 1: Table Of Contents
Quick Installation Guide For MS41p1 Contents Table Contents Table ..................1 Chapter I Introduction ................2 1.1 Overview ..........................2 1.2 Features ..........................2 Chapter II Hardware setup ..............3 2.1 Interface & Indicator Light Introduction ................3 2.1.1 MODEM Indicator Light & Interface Introduction ..........3 2.1.2 Interface of splitter .................... -
Page 2: Chapter I Introduction
Chapter I Introduction 1.1 Overview The MS41p1 supports ADSL, ADSL2 and ADSL2+ over the existing copper lines, with downstream transmission rate up to 24Mbps (ADSL2+) and upstream transmission rate up to 1.024 Mbps. They can support PPPoA (RFC 2364 - PPP over AAL5), PPPoE (RFC 2516 –... -
Page 3: Chapter Ii Hardware Setup
Lucent, Ericsson and so on. ◆ Stable transmission speed even at a transmission distance of 5KM ◆ Supports 8 PVCs Software Features ◆ Supports RFC 1483 protocol (MPOA), RFC 1577 protocol (IPOA),RFC 2364 protocol (PPP over ATM) ,and RFC 2516 protocol ◆... -
Page 4: Interface Of Splitter
Splitter Internet Telephone / Fax Machine DSLAM MS41p1 RJ-45 Cable connect to NIC Note: Splitter is needed to: -Filter out line noise, i.e. - Prevent line noise when there is incoming / outgoing call; - Prevent connection speed drop when using modem. -
Page 5: Chapter Iii Configuration Instructions
Chapter III Configuration Instructions This chapter introduces instructions on how to configure MS41p1 Router. All the following instructions are aimed at Router version, please skip this chapter if the product you purchased is Modem version in that Modem can be used directly without further configuration. -
Page 6: Web Interface Descriptions
Please enter the correct username and password (the default username and password are both admin.) to open the WEB management interface. The main page will be displayed as follows after successful log-on (the actual display might differ with software versions): 3.2.2 WEB Interface Descriptions There are seven options on the main menu on the left side of the main page. -
Page 7: Instructions On The Application Of Common-Use Function Modules
follows: Device Info Including “Summary”, “WAN” info, “Statistics”, “Router” info, “ARP” info and other submenu items. Advanced Setting Including “WAN” setting, “LAN” setting, “Security”, “Routing”, “DSL” and other items. Diagnostics To display the testing result of the status of each connection. Management Including “Setting”, “System Log”, “Access Control”, “Update Software”, “Save/Reboot”... -
Page 8: Dhcp Setting
2) After the modification of IP address for LAN port, you should re-log on WEB management interface via the new IP address. 3) If the new IP address does NOT belong to the same IP section as the original IP address, you need to change the IP of PC web card to conform to the new IP section in order to perform further WEB managing operations on ADSL device. -
Page 9: Chapter Iv Typical Application Cases
4.1 Single-user Log-on (supported both by Modem version and Router version) 4.1.1 Dialing Mode (Dynamic IP) 4.1.1.1 ADSL Setting: No setting modification is required on the MS41p1, please adopt the default settings; 4.1.1.2 Computer Setting: A special dialing software needs to be installed on user PC, software such as EnterNet300, EnterNet500 or WinPoET, etc. -
Page 10: Multi-User Log-On (Supported Only By Router Version Via Its Router Feature)
Note: The default PVC connection parameters can meet the needs of the majority of areas, so user is not required to reset the parameters; if the modification of relevant parameters is desired, please delete the original default PVC connection and then create a new connection. (A MER protocol (1/39) is included in the default setting, which cannot be deleted or modified.) Please refer to the following instructions to configure specific application... - Page 11 2） To setup VPI/VCI and service types, please refer to the requirements of network service supplier. Supposedly, VPI:0, VCI:35, then the service type is “UBR without PCR”. 3）After the setup, please press “Next” to enter connection types and packaging setting page.
- Page 12 5）Please press “Next” after the setup to enable IGMP and WAN services, the service name setting page is shown as below: 6）Please press “Next” after the setup to enter the main setting form as shown below. You can check the correctness of the former settings, please press “Back” button for modification if an error occurs.
-
Page 13: Special Line Mode (Static Ip)
4.2.1.2 Requirements to Configure Web Card of User’s PC: LAN IP address, subnet mask and gateway (IP address of LAN port on ADSL) must be preset. Please be noted that every IP address must be at the same IP section as gateway. - Page 14 page. 2）The basic setting methods and interface are identical with “4.2.1 Dialing Mode (Dynamic IP).But they differ on the third step to setup the connection modes. Please select “Bridge” mode on this and press “Next” to the server name setting as shown below: Please press “Next”...
- Page 15 Global411 Internet Services, LLC Model: MS41p1 Rating: 12VDC 500mA Complies with FCC Part 15 & 68 Rules US:HBTDL03BMS41P1 Jack Type: RJ11C REN: 03B FCC Reg NO. : 0020330262 FCC ID： ： ： ： YZAQA-ZBQI-W0NKQQ This device complies with Class B Part 15 of the FCC Rules.
Need help?
Do you have a question about the MS41p1 and is the answer not in the manual?
Questions and answers