Installation - LG SIGNATURE OLED88Z9PUA Safety And Reference

Avoid touching the screen at all times, as this may result
in damage to the screen.
Do not place the product on the floor with its front facing
down without padding. Failure to do so may result in
damage to the screen.
Please do not pile stuff up on or press down strongly
on the speaker. This may result in product damage or
degradation.

Installation

A
A
• It is recommended to install the product on the floor.
Do not apply foreign substances (oils, lubricants, etc.) to
the screw parts when assembling the product. (Doing so
may damage the product.)
If you install the TV on a stand, you need to take actions
to prevent the product from overturning. Otherwise, the
product may fall over, which may cause injury.
Do not use any unapproved items to ensure the safety and
lifespan of the product.
Any damages or injuries by using unapproved items are
not covered by the warranty.
Make sure that the screws are fastened tightly. (If they are
not fastened securely enough, the TV may tilt forward after
being installed.)
Do not fasten the screws with excessive force otherwise
they may strip and become loose.
6
Connections
You can connect various external devices to the TV. For more
information on external device's connection, refer to the manual
provided with each device.
• Certain 8K input/decoding standards may not be supported.
Antenna/Cable
B
Connect an antenna, cable, or cable box to watch TV while referring to
the following. The illustrations may differ from the actual items and an
A
RF cable is optional.
• Make sure not to bend the copper wire of the RF cable.
<
A =
10 cm (3.94 in)
<
B =
2 cm (0.79 in)
• Complete all connections between devices, and then connect the
• Use a signal splitter to use 2 TVs or more.
• DTV Audio Supported Codec: MPEG, Dolby Digital
• This TV cannot receive ULTRA HD (3840 x 2160 pixels) broadcasts
An additional device may be necessary to support certain 8K
standards. Upscaled and enhanced 8K images will vary depending
on the source content.
The product label is attached under the external device connection
terminal cover.
Do not connect too many devices to the same AC outlet. Be sure
the AC outlet has the correct rated voltage and current.
Copper wire
power cord to the power outlet to prevent damage to your TV.
directly because the related standards have not been confirmed.