Syride SYS'Evolution User Manual page 29

Here are the waypoint types available in competition mode:
Take-Off: This waypoint is optionnal and can only be set as the first waypoint of the route. It's not
used for navigation, but allows to display the full length of the task.
Start of Speed Section (SSS): This waypoint is mandatory in a competition route creation. It can
be validated by entering it (enter) or exiting it (exit). A start time must be defined.
- SSS in a Race to goal task: With an Exit Start, if the pilot is inside the cylinder at the
Start time, the Start is validated, and the Sys'Evolution switch the navigation to the next
waypoint. With an Enter Start, if the pilot is inside the cylinder at the Start time, the
waypoint will only be validated upon cylinder entry crossing after the start time. In both
cases, the competition time will begin as of the start time (SSS validated or not).
- SSS in an Elapsed time task: unlike in race to goal tasks, the competition time will only
start after crossing the Start cylinder (Enter or Exit direction) after the start time. It is
possible to cross as many times as desired the start cylinder, the competition time being
reset each time you cross it, as long as you haven't validated the next waypoint.
SSS in Race to Goal with multiple starts tasks: In addition to classic Race to Goal
-
tasks information, you will have to enter the number of gates and the time intervals
between these gates. Here's an example of tasks using multiple starts: A task with 5
EN
27