Programming Examples - Whelen Engineering Company E-969 Installation & Operating Manual

Remote Input 1 or 2:
Tmx Warm Up
Area Code:
Base I.D.:
Precheck Digit:
Precheck Duration:
Channel Grant Wait:
Channel Grant Delay:
Reset Programming:

Programming Examples

Before beginning any programming it is important to write down what will be programmed. Be sure to make
note that a minimum of a 2 second delay time is required.
Example:
Key# Sequence#
1 00
1 01
Select the command or function by using the COMMAND GROUP keys and the
arrows. Press PRECHECK when the desired function appears on the display. Use
the numeric keypad to select the Address and press PRECHECK to enter. Press
PRECHECK to save.
To set the Remote Input equal to a Call Key, press Call Key C1 at the command
prompt. Then enter the appropriate Call Key number through the numeric keypad.
Press PRECHECK to enter. Press PRECHECK to save.
Use the numeric keypad to select a value (0.0-9.9). The decimal point is fixed.
Press PRECHECK to enter. Press RESET to return to the Stand By display or an
UP or DOWN arrow to scroll to a different parameter.
Use the numeric keypad to select a value (000-999). Enter three digits. Press
PRECHECK to enter. Press RESET to return to the Stand By display or an UP or
DOWN arrow to scroll to a different parameter.
Use the numeric keypad to select a value (0-7). Press PRECHECK to enter.
Press RESET to return to the Stand By display or an UP or DOWN arrow to scroll
to a different parameter.
Use the numeric keypad to select a value (0-9). Press PRECHECK to enter.
Press RESET to return to the Stand By display or an UP or DOWN arrow to scroll
to a different parameter.
Use the numeric keypad to select a value (0-9). Press PRECHECK to enter.
Press RESET to return to the Stand By isplay or an UP or DOWN arrow to scroll
to a different parameter.
Use the numeric keypad to select a value (1-9). Press PRECHECK to enter.
Press RESET to return to the Stand By Display or Scroll to a different parameter.
Use the numeric keypad to select a value (.0-.9). Press PRECHECK to enter.
Press RESET to return to the Stand By Display or an UP or DOWN arrow to scroll
to a different parameter.
Press PRECHECK to reset all of the programmable parameters.
Command
Wail
Cancel
Address
####
####
Page 10
Delay
030
002