Advertisement
Quick Links
Content
Ⅰ. Attention .................................................................................2
Ⅱ. Equipment Compose .............................................................2
Ⅲ. Main Function ........................................................................4
Ⅳ. Installation Diagram.............................................................10
Ⅴ. Application........................................................................15
Ⅵ. Specification.....................................................................16
Ⅶ. Important Safety Precautions.............................................16
Ⅷ. Guarantee ....................................................................18
Advertisement
Summary of Contents for Wizard Electronics ON-MTC138-4G
-
Page 1: Table Of Contents
Content Ⅰ. Attention …………………………………....….………………2 Ⅱ. Equipment Compose ……………………..……………………………2 Ⅲ. Main Function …………………………….....………………4 Ⅳ. Installation Diagram……...…………………………….………………10 Ⅴ. Application…………………..…………………………….……………15 Ⅵ. Specification……………………………..………….…………………16 Ⅶ. Important Safety Precautions………………………………………16 Ⅷ. Guarantee …………………..………………………………………18... -
Page 2: Ⅰ. Attention
Ⅰ. Attention 1. Make sure to read this manual carefully before using this product. 2. Please insert the SIM card before installing, and make sure the SIM card has no password, otherwise the tracker will not work normally. 3. Please make sure that all the cables of the tracker has been connected rightly, and then connect the terminal to host power. -
Page 3: Ⅲ. Main Function
Start Up： Put the SIM card in place and installed the terminal in the car, the red indicator light is on. About 20 seconds, the terminal will begin to work and acquire the mobile network signal as well as the GPS/Beidou signals, and the red indicator light will keep flashing every 2 seconds when the mobile module is no communication. - Page 4 vehicle is overspeed, the unit will send the overspeed alert to all authorized numbers. 7. Geo-fence: Set up a geo-fence for the unit to restrict its movements within a district. The unit will send the message to all authorized numbers when it beyond the district. 8.
- Page 5 to the unit. If the platform‟s web name and port arewww.gps.com:1234 and device number is 13480887466,please send SMS"*setweb,www.gps.com,12345,13480887466#"to the tracker. 3. Set APN In order to send GPS data to IP address, you still must set mobile network Access Point Name (APN).
- Page 6 8. Change the Password Send SMS to device, command as follow format, password + OLD PASSWORD + SPACE + NEW PASSWORD to change the password. For example: Send SMS "password123456 168168"." password" as instructions, "123456"as old password, "168168" as new password. Password must be Terminal‟s initial password is 123456.
- Page 7 can‟t monitor this unit. 12. Overspeed alert Set up: Send SMS speed+ PASSWORD +SPACE+Speed to the unit. For example, send SMS "speed123456 080". "speed" as instructions, "80" as limit speed, "123456"as password. Cancel: Send SMS speed+ PASSWORD cancel to deactivate the speed alert. 13.
-
Page 8: Ⅳ. Installation Diagram
degrees, tracker will upload GPS data to server at ones. Below 10 is close this function. 18. Set input voltage as ignition on For some special case, custom don‟t connect the ignition detecting line to the car. Terminal support to set the input power checking as ignition on/off. To set this function, you can send SMS to device, the format is *ignvol,VOL# For example "*ang,9.2#", "9.2"... - Page 9 Type Model SM-4 connector Description Function Pin Function Grand Ignition Detection Fuel control Power in, 9~55V Type Model Molex 3.0mm connector Description Function Pin Function 5V out RS232_TXD RS232_RXD Type Model SM-2 connector Description SOS or Temperature sensor , OEM pins Vehicle Terminal Installation Vehicle terminal should be installed by technical professional of local service center.
-
Page 10: Ⅴ. Application
3. Wire for cutting off circuit of the tracker White wire connects relay pin 86,85 pin to 12 V DC, 87 pin and 30 pin are in series power supply circuits. Caution: Wrong connection of yellow wire will damage the tracker. 4. -
Page 11: Ⅵ. Specification
Ⅵ. Specification: Item Terminal ON-MTC1x8 ON-MTC2x8 ON-MTC3x8 ON-MTC6x8 850MHz,900MHz,1800MHz,1900MHz CDMA 800MHz WCDMA 2100/1900/900/850MHz FDD-LTE 800/850/900/1800/2100/2600MHz GPS Chip Ublox7/Compass GPS Sensitivity -160dBm 3 – 30m GPS Accuracy Network SMS,GPRS,CDMA 1x,3G,4G Way of Tracking Cell Phone or Platform Dim. 66*46*25mm 86*56*25mm 86*63*27mm 114*90*30mm Weight 0.126Kg... - Page 12 affecting the normal operation of this product. 8. Do not demolish antenna yourself, and also cannot use other antennas of other objects to replace, this may seriously affect the quality of communication, and may even change the antenna radiation harmful to your health. 9.
-
Page 13: Ⅷ. Guarantee
Ⅷ. Guarantee Please Guarantee preserve this card for free repair User File:Date: User name Address Telephone Purchasing address Retail price Purchasing Commodity Model No. name and specification Signature of User Dealer Signature Guarantee Item: 1. Three months upon date of purchase, if there is function problem, we should offer the same item subject to goods and packing maintain perfect.