Advertisement
6989.SH3300 12pp IB + Rego.qxd
Care and Cleaning
• Do not immerse the shaver in water or any
other liquid.
• Press the two shaver head release buttons
and pull the shaver head from the casing
• Tap the shaver head on a flat surface or
blow the hairs out thoroughly (fig. 1).
• Clean the cutter blocks using the cleaning
brush supplied.
• Never use the brush on the foil as this may
damage it.
Changing the foil and cutter blocks
Shaving performance depends on the
condition of the foil and the cutter blocks.
Both wear gradually in use. Therefore it is
recommended that the shaving foil be
changed once a year and the cutter blocks
changed every two years.
3/5/04
9:34 AM
Replacing the shaving foil
• Remove the shaver head by pressing the
two release buttons.
• Pull the shaving foil out of the shaver head
by holding it on the attached straps (fig. 2).
• Place the new shaving foil in the shaver
head until it clicks in position.
• Replace the shaver head.
Replacing the cutter blocks
(fig. 1)
• Remove the shaver head
• Hold the cutter blocks on both sides and
lift them from their supports (fig. 3).
• Place the new cutter blocks in position.
• Replace the shaver head.
Page 7
(fig. 2)
(fig. 3)
5
Advertisement
