Bullhorn DMR-800 Upgrade Manual

Installation and Configuration
Required Tools
Field Update Tool (FUT) -

Blue FUT for RM4010 or RM4011
Red FUT for RM4013
Replacing the Satellite Terminal
The following procedures are general steps for a typical installation. For additional information, please contact Technical
Support at 1-800-229-3404 or support@aiworldwide.com.
WARNING To prevent electrostatic discharge (ESD) damage when handling electronic equipment, always wear an anti-static
:
wrist strap attached to an unpainted, grounded metal object. Ensure the wrist strap has maximum contact with bare skin.
A replacement fuse is included in the IDP Conversion Kit in the event the unit's fuse is blown. For additional informa-
NOTE:
tion, refer to the RM4000 Series User Guide available on the Bullhorn RMU Support Site (support.aiworldwide.com).
1
Power off Unit & Switch Terminals
Open Unit cover and power down the Unit.
1
Disconnect Satellite Terminal cable from Unit.
2
Unmount the DMR-800 Satellite Terminal.
3
4 Mount IDP Satellite Terminal in existing mounting bracket using the
included screws. Ensure terminal is pointing due south of Mexico.
5 Connect IDP Satellite Terminal to Unit.
6 Power on the Unit.
Wait until the Unit's Radio LED is a solid green before proceeding.
IMPORTANT:
2
Upgrade Firmware
Attach FUT to Unit's Firmware Upload
1
serial port. The update begins automatically.
Do not turn off the unit during the update
IMPORTANT:
process.
LED lights on the FUT:
2
Status LED light indicates when FUT is updating or complete.

Activity LED light ashes during the veri cation and update process.

When the Completed status light turns on and the Activity light turns off,
3
disconnect the FUT.
LED lights on the Unit:
4
The Acquiring Signal light ashes to indicate Unit is searching for satellite

signal.
The Packet Queue light ashes to indicate Unit is transmitting. The light turns

off when Bullhorn Web receives the packet.
Unit automatically sends a packet when update is complete to register the

new terminal with the Unit.
IMPORTANT: Unit must complete packet transmission to complete the update.
If packet transmission is not successful, repeat the rmware update process.
WARNING: If wires are to be buried or covered, use conduit to protect the wires.
August 2019
RM4010
Anti-static wrist strap

Adjustable wrench

Small Phillips head screwdriver

Small slotted screwdriver

IDP Satellite Terminal Upgrade
Quick Reference Guide
Optional Hardware/Software



Blue FUT
(part no. 826183-000)
1 of 2
Quick Reference Guide
Windows Laptop PC
®
USB Mini-b cable
Bullhorn Tools con guration software
®
Red FUT
(part no. 826183-100)
RM4011 Port, Switch, and LED Lights
(Continued on back)
Part No. 122240-000 Rev. 0