Box Contents - Global 641375 User Manual

BOX CONTENTS

Qty. Description
1
Motor Body with Cord
1 Plastic Handle
2 Metal Handle Tube
2 Scrub Brushes
4 Microfiber Pads
4 Carpet Bonnets
4 Felt Pads
4 Scrubbing Pads
ASSEMBLY
1. Using a Phillips head screwdriver
(not included), remove the screw from
the plastic handle. Slide metal handle
tube into the plastic handle, align the
holes, reinstall, and tighten the screw.
2. Locate the other metal handle tube
and slip the end with one hole over the
plastic handle connector on the finished
handle assembly. Make sure the locking
pin protrudes through the hole in the
side of the lower tube.
3. Remove the screw from the black
painted yoke, and insert the metal
handle tube into the yoke. Reinstall the
screw, and tighten.
Scrub Brushes
Deep cleaning of grout,
Ideal For:
tile, concrete, carpets and
heavily soiled floors
Mini Floor Scrubber
Handle
Screw
Lockpin
Yoke
Screw
Microfiber Pads Carpet Bonnets
Hard floor cleaning and Wide-area carpet cleaning
polishing
OPERATING INSTRUCTIONS
1. To Operate: Step on the handle
release, and tilt the handle toward the
rear of the machine. The machine will
start once the handle is tilted slightly.
2. To Clean Hard Floors: Attach the microfiber pads on the brushes.
Snap the plastic piece in the center of the microfiber disc onto
the shaft in the center of the brush to securely retain the felt
disc. Spray a small amount of a mild, water-based cleaner on
a small area of the floor and immediately run the machine over
the area. When the pads are dirty, they can be turned over and
re-attached.
3. To Wax Floors: Apply wax to floor and allow it to dry completely.
Attach felt discs to the scrubbing brushes. Snap the plastic piece
in the center of the felt disc onto the shaft in the center of the
brush, to securely retain the felt disc.
4. To Clean Carpet: Spray a small section of the carpet with an
"encapsulating carpet cleaner". Run the machine with scrubbing
brushes, on the carpet to work the chemical into the fibers. Once
the encapsulating cleaner has thoroughly dried, vacuum it and
the dirt out of the carpet.
5. To Remove Brushes: Only
remove brushes for cleaning.
Simply pull off, do not
remove any screws, etc. All
accessories are designed to
be used with the brushes on
the machine.
6. Cleaning of Pads: Microfiber
pads and carpet bonnets are
washing machine safe. Felt
pads must be hand washed.
Felt Pads
Cleaning and polishing
hardwood floors to a high
2
User's Manual
Handle
Release
Pull off brush to remove
(do not remove screws)
Scrubbing Pads
Heavily soiled hard floors
such as tile and concrete
shine