Advertisement
Installation & Operator's Instruction Manual
Introduction
The Airspeed Sensor is used to measure the air speed in a tunnel ventilated building. Using this equipment
for any other purpose or in a way not within the operating recommendations specified in this manual will
void the warranty and may cause personal injury.
Safety
DANGER !
May 2017
Air Speed Sensor
Electrical Hazard
Disconnect electrical power to the
Control and to ALL electrical
devices connected to the Control's
Relay Box before installing the
update kit! Failure to disconnect
power to equipment connected to
Relay Box could result in personal
injury.
MT1828B
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Chore-Time MT1828B
Summary of Contents for Chore-Time MT1828B
- Page 1 Disconnect electrical power to the Control and to ALL electrical devices connected to the Control's Relay Box before installing the update kit! Failure to disconnect power to equipment connected to Relay Box could result in personal injury. May 2017 MT1828B...
- Page 2 Effective: May 2017 Thank You employees of CTB Inc. would like to thank your for your recent purchase. If a problem should arise, your CTB distributor can supply the necessary information to help you. MT1828B...
- Page 3 (3) #8 screws (Item 3) provided. It is recommended that the board be connected to the ceiling using a Hinge (not provided). This is to allow the Sensor to be lifted out of the way during cleanout. Item Description Mounting Bracket 2x4 Board #8 Screw Hinge (Not provided) Figure 2. Air Speed Sensor Mounting MT1828B...
- Page 4 The Airspeed Sensor should be oriented so that the axis of the Sensor is vertical and the three plastic cups spin horizontally. Approx. 50’ [15.2 Meters] Axis Vertical Center of House 3’ [1 Meter] Floor Tunnel Fans Item Description Air Speed Sensor Figure 3. Air Speed Sensor location MT1828B...
- Page 5 Wiring The Airspeed Translation Box can be placed anywhere in line between the Control and the Sensor. Recommended locations would be either right next to the Control or mounted on the Mounting Bracket of the Sensor. 2 (DI) of your Choice GREEN GREEN BROWN...
- Page 6 Page No. Description of Change Added Wiring Diagram 32672 Contact your nearby Chore-Time distributor or representative for additional parts and information. CTB Inc. P.O. Box 2000 • Milford, Indiana 46542-2000 • U.S.A. Phone (574) 658-4101 • Fax (877) 730-8825 Email: ctb@ctbinc.com • Internet: http//www.ctbinc.com...
Need help?
Do you have a question about the MT1828B and is the answer not in the manual?
Questions and answers