Table of Contents
Advertisement
Subsequent Channel Assignment
When you set DimABC, all 6 dimmers are automatically
set sequentially. For example, if you have set DMX
channel 60 for DimA, DimB is now assigned to channel
61, DimC is on 62, and so on, all the way up to DimF
being set on channel 65.
Non-Sequential Channel Assignment
Each set of 3 dimmers, ABC and DEF, are always
sequential, but the two sets do not have to be.
You can use RC4 OneTouch™ with the Set buttons for
each individual group. For example, if you want DimDEF
to be set to DMX address 11, bring up 11 @ 30%
(for the LED curve) at the board and press the SetDEF
button.
Remember: SetABC assigns all 6 dimmers sequentially.
The SetDEF button work individually to set only the
last 3 dimmers. Always use SetABC first, then set DEF
differently if you need to.
10
10
Connecting Your Lamps, LEDs, Motors and More*
To really use your LumenDim6, you must connect a lamp, LED, motor, or other
load to each dimmer. When you're connecting anything to your LumenDim6, be
sure that the LumenDim6 is powered down. Connect everything first, then turn
on power.
red
The
output connections are positive (+), the
Dimming occurs on the negative side. The positive connections are all
connected together inside the LumenDim6.
* DimC , D, E, and F on the LumenDim6 can control a variety of devices including solenoids, relays, servo
motors, and much more. DimA and B are intended for LED dimming only.
Power Input: 6 - 35VDC
Do not exceed voltage
rating for connected loads.
Common Positive
grey
connections are negative (-).
+
11
11
Advertisement
Table of Contents
