Subscribe to Our Youtube Channel
Related Manuals for MYLAN WhisperJECT
Summary of Contents for MYLAN WhisperJECT
- Page 1 Rx only WhisperJECT ™ INSTRUCTIONS FOR USE IMPORTANT: Please read these instructions prior to administering your first injection, even if you have used similar autoinjector devices.
- Page 2 INSTRUCTIONS FOR USE FOR WhisperJECT™ AUTOINJECTOR For single patient or individual use only. For Rx only. The WhisperJECT Autoinjector is intended for use with FDA-approved drug products with non-viscous (aqueous) liquid formulations, which are presented in a 1.0 mL BD , pre-fi lled, glass syringe with staked ®...
-
Page 3: Important Warnings
Orange Needle Cap Remover and Syringe Only use the 1.0 mL BD , pre-filled, glass ® The WhisperJECT™ Autoinjector is good for two years from first Housing to reset the device. syringe with staked needle, containing a day of use and should then be replaced. - Page 4 AUTOINJECTOR PARTS 1.0 mL BD , PRE-FILLED, GLASS SYRINGE ® (Not Included with WhisperJECT™ Autoinjector Kit) Handle Needle Depth Orange Needle Injection Syringe Glass Rim Setting Value Cap Remover Button Plunger Housing Needle Cap Plunger Viewing White Alignment Needle Depth...
- Page 5 Wash hands with soap and water prior to handling supplies. WhisperJECT™ Autoinjector 1.0 mL BD , pre-fi lled, ® Glass Syringe Gather the following supplies: • WhisperJECT™ Autoinjector in • Clean damp cloth for device Protective Case cleaning post-injection (not included with device) • 1.0 mL BD ®...
- Page 6 Step 1 – Attach the Orange Needle Cap Remover Insert the Orange Needle Cap Remover into the Syringe Housing. Note: The Orange Needle Cap Remover Remove the Handle, Orange Needle Cap Remover and does not click into place. Syringe Housing from the Protective Case. DO NOT continue to Step 2 until the Orange Needle Cap Remover is inserted.
- Page 7 Position the Handle above Step 2 – Reset the Autoinjector the Syringe Housing with the open end of the Handle Place the Syringe Housing on a clean flat surface with the against the Orange Needle Orange Needle Cap Remover end up. Cap Remover.
- Page 8 Step 3 – Set the Needle Depth Confi rm the Autoinjector is reset. BEFORE AFTER When the Autoinjector is reset: Rotate the Orange Needle Cap Remover until the desired depth value (4, 6, 8 or 10) • The white check mark inside a is aligned with the blue semi-circle (see green box will no longer be visible image left).
- Page 9 , pre-fi lled, Glass Syringe from the protective blister packaging. (1.0 mL BD ® , pre- fi lled, Glass Syringe is not included with the WhisperJECT ™ Kit.) DO NOT remove the 1.0 mL BD ® pre-fi lled, Glass Syringe Needle Cap.
- Page 10 Step 5 – Reassemble the Autoinjector Step 6 – Select and Clean Injection Site Reassemble the device by Place the Autoinjector on a clean aligning the white arrows and surface before preparing your turning the Syringe Housing injection site. until it locks into the Handle. You will hear a “CLICK”...
- Page 11 Turn the Orange Needle Cap Remover Save the Orange Needle Step 7 – Remove the Syringe Needle Cap upside down over a table to allow the Cap Remover for future use. pre-fi lled Syringe Needle Cap to fall out. Hold the Handle with one hand and the Orange DO NOT dispose of Needle Cap Remover in your other hand, and...
- Page 12 Press the Injection Button to start Step 8 – Inject the Dose the injection. You will hear a “CLICK” when the injection has started. Gently place the Autoinjector straight on the injection site (not at an angle). Continue to hold the Autoinjector down against the injection site.
- Page 13 Step 9 – Confi rm Full Dose Received Step 10 – Remove and Dispose of the Used Syringe When your injection is complete, remove the Carefully and slowly unscrew the Carefully hold and tip the Autoinjector straight up from the injection site. Syringe Housing from the Handle.
- Page 14 Step 11 – Clean the Autoinjector Step 12 – Place the Autoinjector in Protective Case for Storing Wipe the external parts and the accessible areas of the Syringe Holder and Handle with a clean, damp Store the Autoinjector in the Protective cloth after each use.
- Page 15 Manufactured for: Mylan Pharmaceuticals Inc. Distributed by: Mylan Pharmaceuticals Inc. *WhisperJECT™ is available by prescription only WhisperJECT™ is a trademark of Mylan Pharmaceuticals Inc. is a registered trademark of Becton, Dickinson and Company. ® For more information call 1-877-446-3679 (1-877-4-INFO-RX) or visit Mylan.com...
Need help?
Do you have a question about the WhisperJECT and is the answer not in the manual?
Questions and answers