Operating instructions POWERMOON® - POCKETMOON® Introduction ® Thank you for choosing a product from POWERMOON . Please read through this manual ® carefully before using the Pocketmoon , and store it in a safe place so that you can refer to it later if necessary.
Operating instructions POWERMOON® - POCKETMOON® Contents Introduction ........................2 Please read this first ...................... 2 1.0 Identification ......................4 1.1 Product name and type designation ............... 4 1.2 Product version ....................... 4 1.3 Name and address of the manufacturer ..............4 2.0 Product description ....................
– whether it’s road or railway construction, search and rescue operations, event lighting or temporary lighting of a car park. The POWERMOON light is for indoor and outdoor use. ®...
When you are transporting or passing high voltage power lines with a vehicle on which a POWERMOON device is installed, it is essential to observe the prescribed safety distances: 50 metres distance from overhead power lines, at least 2.5 metres distance from power lines over tracks.
POWERMOON may, as the power-consuming device with the highest output, cause damage to the other devices on the same supply circuit when it is switched on and off i.e. the power surges and phase shifts that take place during the switching process.
Operating instructions POWERMOON® - POCKETMOON® 3.0 Definitions 3.1 Safety information in these operating instructions This manual contains security guidelines which fall under the categories DANGER, WARNING, CAUTION, ATTENTION and COMMENT. These should be followed to reduce risk of injury, equipment damage or improper service.
ALWAYS ensure that the POWERMOON tilt, roll, slip or fall. 3.2.3 NEVER use a POWERMOON which is in need of repair. A POWERMOON is in need of repair if: - The electric cable is damaged - The plug is not securely screwed or overheated...
3.3.1 After repairs / maintenance work, ALWAYS replace the protection devices. ® 3.3.2 Ensure that NO water collects around the console of the POWERMOON . If there is ® any water there, move the POWERMOON away and let it dry before undertaking maintenance efforts.
ALWAYS be stored in the transportation bag if it is not being used. ® 4.1.2 During transportation, the POWERMOON should ALWAYS be well protected. If this ® rule is not observed, the POWERMOON may end up damaged. ® 4.1.3 The POWERMOON may be stored either horizontally or vertically. ®...
Operating instructions POWERMOON® - POCKETMOON® 4.4 Safe disposal of the packaging material The client can dispose of the cardboard. Recommended disposal: Old paper recycling (cardboard) 4.5 Preparatory work prior to installation The installation location should meet the following criteria: Single storey with a surface area of at least 5 x 5 metres...
Place the power supply over the top of the tripod and push it to the bottom of the pole. ® 4.6.6 Screw the magnetic connection on top of the tripod and place the Pocketmoon light panels on top of it. Rev. 1001_EN...
Operating instructions POWERMOON® - POCKETMOON® 4.7 Attach light on tripod (if appropriate) Risk of electric shock. Electric shocks can result in serious injury or death. Under all ® circumstances, the POWERMOON should only be plugged in and switched on after it has been fully unpacked and assembled.
Operating instructions POWERMOON® - POCKETMOON® 4.7.3 Loosen the screw on the ball joint swivel head and adjust the angle for the light to your needs and tighten the screw to fix it. 4.8 Connecting the lamp 4.8.1 Insert one end of the cable in the hole under the LED panels. Check, that while inserting the cable that the edges on the cable match the edges of the hole and once inserted, turn the cable counterclockwise to lock it.
Operating instructions POWERMOON® - POCKETMOON® 4.9 Adjust the height of the tripod 4.9.1 Adjust the height of the tripod by your needs by turning the extension points on the tripod counterclockwise, then lifting the extension and locking it by turning clockwise.
Operating instructions POWERMOON® - POCKETMOON® 4.10 Storage and protection during interruption of normal use ® 4.10.1 When the POWERMOON is not in use, it does not need to be completely dismantled. The light remains stable in the wind even when it is switched off. The following additional points regarding operational safety (3.2) must also be observed:...
Operating instructions POWERMOON® - POCKETMOON® 5.0 Maintenance and cleaning 5.1 Maintenance and cleaning by the user ® 5.1.1 The POWERMOON cases may be cleaned by wiping them with a damp cloth. Never use abrasive cleaners like benzine, thinner or other products which can make the material deteriorate.
Need help?
Do you have a question about the POCKETMOON and is the answer not in the manual?
Questions and answers