Table of Contents
Advertisement
Quick Links
KOLECTRIC
Micro Covermeter 8020
CONTENTS
1.
UNPACKING
2.
EQUIPMENT
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
** OPTIONAL EXTRA
INSTRUCTION
MANUAL
Page
11
12
13
14
15
15
16
17
17
17
Kolectric Research Limited
Couching House, Couching Street
Watlington, OX49 5PX United Kingdom
UNPACKING
1.
On receipt of your new Micro Covermeter 8020 ( MC 8020 )
unpack carefully and examine items for any possible transit
damage. Any such damage should be notified to your
supplier and carrier immediately.
1
EQUIPMENT
2.
1
The following items are included in the specially designed
2
Carry Case.
Micro Covermeter 8020 instrument with integral re-
4
chargeable battery.
9
Shoulder harness and wrist strap.
AC/DC adaptor for battery charging, with cable and
connector.
Probe
Spacer
Connection cable
Download cable and software
Earphone
On-site charger *
* If specified at time of order.
On receipt it should be noted that the on-board battery has
approximately 20% of a full charge available which will be
sufficient to enable the function check described below to
be carried out. However, prior to first time use in the field, it
is necessary to fully charge the unit.
Tel: +44 (0) 1491-613523
Fax: +44 (0) 1491-613339
enquiries@kolectric.com
www.kolectric.com
1
Advertisement
Table of Contents
Related Manuals for Kolectric 8020
Summary of Contents for Kolectric 8020
- Page 1 Fax: +44 (0) 1491-613339 enquiries@kolectric.com www.kolectric.com CONTENTS UNPACKING On receipt of your new Micro Covermeter 8020 ( MC 8020 ) unpack carefully and examine items for any possible transit damage. Any such damage should be notified to your Page supplier and carrier immediately.
- Page 2 The display will change to the sample below. At the "MC 8020", together with a software version number and the time that the key is pressed there will be a high-pitched serial number of the instrument.
- Page 3 Pressing the right hand yellow 'Softkey' button above which By default the cover units will be in mm. If this is as required can be seen on the display the icon of an inverted triangle, then you may change the bar size to the known or an you will see that the highlighted bar moves down the menu.
- Page 4 eventually show white. At this stage the stick-on baseplate be made. The instrument calibrates both ranges in should be replaced to prevent damage to the probe housing succession and this can be noted on the display. which may reduce the IP65 rating. The K9 probe has a small red LED in the keypad.
- Page 5 MC 8020 after the on-board power supply has been exhausted. Method of operation. The unit is connected to the MC 8020 via the same socket as the normal mains charger. Access the Cover depth screen and locate the bar as described above.
Need help?
Do you have a question about the 8020 and is the answer not in the manual?
Questions and answers