Advertisement
Mounting the Speaker
The sub should fit in the opening you cut with no more
than a 3/16" gap around the sub. There are 2 included
wood templates (2 thicknesses), install one, both or
neither to get the sub to lay close to the wall surface.
Now screw the sub into the studs.
IMPORTANT!
You must now play music through the
speaker before continuing to the next step.
Finishing
After testing the the sub and assuring everything is
correct you will need to lay the included mesh over the
subwoofer and trim out about 1" around the port at the
bottom of the subwoofer.
1"
Next have a skilled drywall spackler fill in the gaps
around the sub with drywall spackle ( DO NOT USE -
lightweight joint compound) and lay the included
drywall mesh over the joint compound over the
seams. Next spackle the entire speaker area smooth
to blend into the wall, no thicker than 2mm.
Once the joint compound is dry, sand smooth and
paint.
Alternative Way to Wire W24 Speaker
Wiring WR24 Speaker - Dual Voice Coil
Speaker
In order to wire the WR24 as a dual voice coil speaker
you MUST purchase an additional WRPRO (two
3/16" Gap
total).
Remove the black and red jumper wire.
WR24
Remove
WR24
3
Advertisement
