Summary of Contents for Datasensor SE-SRT Series
- Page 1 ACCESSORIES FOR SAFETY DEVICES - SE-DM: series: deviating mirrors - SE-LP: series: laser pointer - SE-S: series: floor stand SE-SR2 series: safety relay SE-SRT series: connection box...
-
Page 2: Installation
Hence particular attention has to be taken during system alignment and part fixing. - To facilitate system installation (mirror/s and safety light curtain) the use of the Datasensor SE-LP laser pointer is suggested. The drawing shows an area protection system composed of a safety light curtain and two mirrors. -
Page 3: Laser Pointer
INSTRUCTIONS FOR USE • Install the emitting and receiving units of the SE series safety device in the defined positions (refer to MECHANICAL MOUNTING chapter of the safety light curtain instructions manual). The use of the SE-S floor stands are recommended, verifying that they are firmly fixed and that their axis is perpendicular to the floor. -
Page 4: Floor Stand
DIMENSIONS Model L (mm) X (mm) SE-S 800 30x30 SE-S 1000 1000 30x30 SE-S SERIES SE-S 1200 1200 30x30 SE-S 1500 1500 45x45 Floor stand SE-S 1800 1800 45x45 The floor stand of the SE-S series can be used for the installation of both the emitter and receiver units of the SAFEasy safety light curtains series, as well as for the SE- DM deviating mirrors series. -
Page 11: General Information
DATASENSOR S.p.A. warrants its products to be free from defects. DATASENSOR S.p.A. will repair or replace, free of charge, any product found to be defective The use of one single relay can reduce the system’s safety To guarantee the correct isolation and avoid damage as well as during the warranty period of 36 months from the manufacturing date.