Advertisement
SECTION ONE
Important Information
Your shower is designed and tested to the
very highest standards and complies fully
with all of the relevant national/intemational
standards for safety and reliability.
The shower is manufactured in a
BS EN ISO 9002-registered factory
your
assurance of a quality product.
To ensure correct use and maintenance of
the shower, please read and adhere to the
following warnings and guidelines.
For Installers:
1.1
Do not attempt any of the electrical or
plumbing work necessary to install this
product unless you have good practical
experience and adequate understanding of
the lEE Wiring Regulations and Water Bye
Laws.
1.2 WARNING: THIS APPLIANCE
MUST BE EARTHED.
1.3
Before removing your shower heater
cover always ensure your shower heater is
isolated from the electrical mains.
1.4
This product is splash-proof, and is
approved for use in shower cubicles and
over baths. However, do not install the
shower heater in a position where the
handset, in its normally-parked position, will
consistently direct spray over it.
1.Sa
We strongly recommend that you fit
an isolating valve in the pipework to the
shower, in an accessible place. This will be
of great benefit if any maintenance work, or
complete replacement of the shower, is
required later on.
1.Sb
This shower is designed for domestic
use and is not vandal-resistant.
If
it is installed
in an institutional or commercial situation,
frequent inspection may be necessary, and
our guarantee may be affected.
a
For Users:
1.5
If water emerges from anywhere other
than the spray head outlets, do not use your
shower, and refer to the fault-finding section.
1.6 IT IS IMPORTANT TO CLEAN
THE HANDSET SPRAY PLATE
REGULARLY,
particularly in hard water
areas, where this may be necessary as
often as once a week. Failure to do so will
affect the performance of the shower, and
in extreme cases may cause the pressure
relief device to operate.
Refer to Section 6.
1.7 The shower heater outlet, hose
and handset act as a vent. They
must not be blocked, obstructed, or
have connected to them any fitting
not approved by us.
The use of
unapproved accessories may invalidate the
guarantee and affect the performance and
safety of the unit.
1.8
WARNING: DO NOT USE the shower
if the HOSE IS DAMAGED in any way; for
instance if the outer covering has parted to
reveal the inner tube. A damaged hose can
suddenly restrict the flow and result in
extremely hot water from the spray head.
A damaged hose could completely block
the outlet of the shower; the resulting
increase in pressure could burst a
weakened or damaged hose.
1.9
Do not install the shower in a situation
where the water in it could freeze. Any
damage caused by freezing will not be
covered by the guarantee.
If you suspect your shower is
frozen, SWITCH OFF IMMEDIATELY.
Refer to Fault-Finding, Section Five.
1.10
Do not leave young children, the infirm
or the disabled unattended in the shower.
1.11
Before stepping into the shower,
always test the temperature of the spray
with your hand.
1.12
Switch off at the isolating switch
after use. This is a safety procedure
recommended with ALL electric appliances.
Advertisement
