Advertisement

Quick Links

H2
Wasserstoffwa
sser
Generator
Hydrogen Generator
Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Blue H2 and is the answer not in the manual?

Questions and answers

Summary of Contents for SMARDY Blue H2

  • Page 1 0® Wasserstoffwa sser Generator Hydrogen Generator Manual...
  • Page 2 ATTENTION: only use still Water! There should be no carbon dioxide in the water. QUICK START GUIDE S t e p ✔ Fill the hydrogen generator with a little cold water and connect to the power supply, fully charge until the green LED light illuminates ✔...
  • Page 3: Chapter Overview

    Chapter Overview • 01 – General safety instructions • 02 – Scope of supply • 03 – Charge mode • 04 – Operation • 05 – Internal cleaning • 06 – External cleaning • 07 – Hydrogen water– Not only drinking •...
  • Page 4: General Safety Instructions

    1 - General safety instructions ✓ Only operate the device when you have read and understood the instruction manual. ✓ Before you switch on the device, the water container must be filled with water. Otherwise the electrolyc cell could be damaged and this will invalidate the guarantee.
  • Page 5: Scope Of Supply

    2 – Scope of supply...
  • Page 6: Charge Mode

    03 – Charge mode Place the device on a flat and dry surface Fold up the flap over the charging socket at the rear side Connect the narrow end of the USB cable to the charging socket and the other end to the USB port on the charger. Then plug the charger into a 220 V socket- During the charging process the light glows red, when the battery is fully charged, the light glows green.
  • Page 7: Operation

    04 – Operation Attention: Only use still water! There should not be carbon dioxide in the water. Before you switch on, there should be at least 0,1 liter drinking water in the container. Without bottle closure. Ideally, the container should be filled completely because this way it will build up a greater hydrogen pressure and more hydrogen will dissolve in the water correspondingly.
  • Page 8 05 – Internal cleaning / Maintenance After approx. one week or when traces of limescale are visible, the internal part of the generator and the crosshatchured negative electrode which produces the hydrogen, must be cleaned with 1 heaped tablespoon of dissolved citric acid in hot water (approx.
  • Page 9: Technical Data

    06 – External cleaning / Storage / Technical data Wipe the external part of the device with a soft damp cloth. You can also remove coarse impurities by filling the generator half with warm water and shaking vigorously. Store the unit at room temperature and not in direct sunlight. Dimensions Diameter 72 mm.
  • Page 10 07 - Hydrogen water – Not only drinking! In contrast to basic active water from a classic water ioniser, the Ph- value of the treated water remains preserved. Hydrogen water can also be slightly acidic Drink daily up to 0,3 l per 10 kg body weight. At high temperatures and / or heavy physical exertion correspondingly more.
  • Page 11: Troubleshooting

    08 – Troubleshooting Problem Root cause testing Solution Generator does Please read chapter • • membrane not work (very little activated? or no bubble Battery charged? • Battery charged • Please read chapter • development Foreign bodies in • the pressure vessel LED does not light up Battery charged? If necessary connect...
  • Page 12 09 – Legal and Imprint A&B GmbH Blumenstr. 8 86853 Langerringen IMPORTANT INFORMATION This guide contains important information. Read these operating instructions completely through and if necessary several times. Do not throw it away, so that you can always look it up again where appropiate! No responsibility is taken for improper installation, handling and operation.

Table of Contents