Consequences and risks caused by non-compliance with these operating instructions ...... 6 Safety awareness .............................. 6 Safety information for the operator/user ....................... 6 Safety information for maintenance, inspection and installation work............ 6 Unauthorised modes of operation ........................ 7 Replacing the LevelControl Basic 2 BC Control Unit................ 8 Compacta / mini-Compacta 3 of 12...
Conditions which need to be fulfilled before proceeding with the ✓ step-by-step instructions Safety instructions ⊳ ⇨ Result of an action ⇨ Cross-references Step-by-step instructions Note Recommendations and important information on how to handle the product Compacta / mini-Compacta 4 of 12...
▪ The lifting unit/control unit must only be operated with the fluids described in the relevant installation/operating manual. Prevention of foreseeable misuse ▪ Never exceed the permissible operating limits specified in the relevant installation/operating manual. ▪ Observe all safety information and instructions in this supplementary operating manual. Compacta / mini-Compacta 5 of 12...
▪ When taking the pump set out of service always adhere to the procedure described in the supplementary operating manual. ▪ As soon as the work is completed, re-install and/or re-activate any safety-relevant and protective devices. Before returning the product to service, observe all instructions on commissioning. Compacta / mini-Compacta 6 of 12...
Never operate the lifting unit outside the limits stated in the data sheet and in the lifting unit's installation/operating manual. The warranty relating to the operating reliability and safety of the lifting unit supplied is only valid if the equipment is used in accordance with its intended use. Compacta / mini-Compacta 7 of 12...
Also, comply with the instructions for setting the unit type as described below. 13. Set all manual-0-automatic selector switches to "automatic". Setting the unit type NOTE Always set the unit type before setting the inlet nozzle level. Compacta / mini-Compacta 8 of 12...
Page 9
U1.150 E UZS2.150 D UZ11.900 D U1.150 D UZ3.300 D UZ12.900 D U2.150 E UZ4.300 D UZ13.900 D U2.150 D UZ5.300 D UZ14.900 D U3.300 D UZ3.450 D UZ15.900 D U4.300 D UZ4.450 D Compacta / mini-Compacta 9 of 12...
Page 10
(e.g. 1) at the control unit, using the "Up" and "Down" keys. To confirm the selected value press "OK". Press "ESC" to exit parameterisation. Table 6: Setting the inlet nozzle level Inlet Setting [mm] Vertical Compacta / mini-Compacta 10 of 12...