Lifan Wiltec 92494 Manual
  1. Manuals
  2. Brands
  3. Lifan Manuals
  4. Water Pump
  5. Wiltec 92494
  6. Manual
Lifan Wiltec 92494 Manual

Lifan Wiltec 92494 Manual

Gasoline-waterpump
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Manual
Gasoline-Waterpump
Articel 92494 92492 92493 92495 92491
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ
insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities please contact us.
© by WilTec Wildanger Technik GmbH
Seite 1
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de

Advertisement

Table of Contents
loading

Related Manuals for Lifan Wiltec 92494

Summary of Contents for Lifan Wiltec 92494

  • Page 1 Manual Gasoline-Waterpump Articel 92494 92492 92493 92495 92491 Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignificantly. Updating the documentation If you have suggestions for improvement or have found any irregularities please contact us.
  • Page 2 The information contained in this document is subject to change without prior notice. No part of this document can be copied or duplicated in another form without the prior written consent of WilTec Wildanger Technik GmbH. The WilTec Wildanger Technik GmbH assumes no liability for any errors in this user manual or the connection diagram.

  • Page 3: Important Notices

    IMPORTANT NOTICES Please pay special attention to statements preceded by the following words: WARNING: A warning is used to alert the user to fact that hazardous operating and maintenance procedures may result in injury to or death of personnel if not strictly observed.

  • Page 4: Parts Description

    Don’t run the engine in an enclosed room and poor-ventilated place, since  exhaust emission from the engine contain toxic carbon monoxide (CO), which may make people lose consciousness, even lead to death. 2. PARTS DESCRIPTION (Fig.1) 3. PRE-OPERATION PREPARATION 3.1 Connecting water inlet pipe Use commercially available hose, hose joint and clamp.
  • Page 5 3.2 Connecting the water outlet hose Use commercially available hose, hose joint and clamp. A short hose with a big diameter is the best. A long hose with small diameter will increase flowing resistance and decrease the power output of the water pump. NOTE Tighten the hose clamp to avoid falling off under high pressure.
  • Page 6 (Fig.4) CAUTION: Running with insufficient engine oil can damage the engine severely. 3.4 Check fuel level Remove the fuel tank cap and check the fuel level, if the fuel level is too low, refuel more. Only use specified gasoline in the manual (Recommend to use unleaded gasoline). Do not use the combination of engine oil and gasoline or filthy gasoline.
  • Page 7 3.5 Air cleaner filter element check Dismount the thumbnut, washer and air cleaner cover. Check the filter element, if too filthy or clogged, clean it. CAUTION: Do not run the engine without the air cleaner installed,otherwise dirt, dust and other staff will be inhaled into the engine through the carburetor, resulting in premature wear of the engine.

  • Page 8: Operation

    4. OPERATION 4.1 Before operation For your safety, and to maximize the service life of your equipment, it is very important to take a few moments to check its condition before you operate the pump. Be sure to take care of any problem you find, or have your service dealer to correct it.
  • Page 9 (Fig.8) 4.2.4 Move the throttle valve level away from the LOWER position, about 1/3 of the way toward the UPPER position. 4.2.5 Turn the engine switch to the ON position. 4.2.6 Pull the starter handle lightly until resistance is felt, then pull it briskly. Do not allow the starter handle to snap back against the engine.

  • Page 10: Maintenance

    NOTE After stalling the engine in emergency, turn the engine switch to OFF position. 6. MAINTENANCE To keep the water pump at optimal performance, check and adjustment on it periodically is necessary. Regular maintenance and service may extend its service life obviously. The Maintenance Schedule below specifies how often you should have your water pump served, and what things need attention.
  • Page 11 Once touch engine oil, clean your hands with soap in fresh water. NOTE Handing discarded engine oil in accordance with relative environmental protection rules. It’s better for you to take it in a sealed container and take to local recycling station. Do not pour at will.
  • Page 12 6.3.4 Check that the spark plug gasket is in good condition, or replace with a new one. Drive it into the engine with a spark plug wrench to protect thread from being damaged. NOTE Installing a new spark plug, after it touch and oppress the gasket, twist 1/2 more turns; as to a used one, twist 1/2-1/4 more turns.

  • Page 13: Troubleshooting

    WARNING: Gasoline is extremely inflammable and explosive in certain conditions. Turn the fuel cock to OFF position; drive off the fuel drain plug of the carburetor floater  chamber, drain out the fuel in the carburetor. Hold drained gasoline in proper container. Turn the fuel cock to ON position.

  • Page 14: Specifications

    9.2 Water pump cannot pump Check according to the following: Check if there is enough water;  Check if the filter is clogged;  Check if the hose clamp is tightening securely;  Check if the water hose is damaged; ...

This manual is also suitable for:

Wiltec 92493Wiltec 92495Wiltec 92492Wiltec 92491

Table of Contents