molex RFR-00082 Installation Instructions

1u 24 port configurable fiber sliding drawer

RFR-00082 – 1U 24 PORT CONFIGURABLE FIBER SLIDING DRAWER

DIRECTION BELOW APPLY SPECIFICALLY TO THE ENCLOSURE

Installing adjustable mounting angles (Fig.1)



The mounting brackets can be installed in one of two positions which effects Depth of the

enclosure is installed in the rack or cabinet.



Use M4 Philips pan head screws to attach mounting brackets to the enclosure.

Open/close slide drawer (Fig.2)



Release the plunger from grommet.



Use even pressure on both the right and left side to pull and push the drawer.



Slide drawer out to its point of full extension.

EC/ECM NO: 108434

SAP EC NO: 10794823

MPN/FMT-042 (2016/07/01 REV-00).

THIS INFORMATION IS CORRECT AS AT THE TIME OF PUBLICATION, SPECIFICATION ARE SUBJECT TO CHANGE

INSTALLATION INSTRUCTIONS

SAP NO : 187000366

http://www.molexpn.com/

BEFORE INSTALLING OR ADJUSTING THIS PRODUCT,

PLEASE READ THESE INSTRUCTIONS CAREFULLY.

PLEASE KEEP THIS GUIDE FOR FUTURE REFERENCE

Fig.1

Doc No: AS-18700-101 Doc part: AS

REV- A1

DATE: 2016/SEP/27

SHEET No. 1 of 4

Table of Contents

Need help?

Do you have a question about the RFR-00082 and is the answer not in the manual?

Page 1 BEFORE INSTALLING OR ADJUSTING THIS PRODUCT, INSTALLATION INSTRUCTIONS PLEASE READ THESE INSTRUCTIONS CAREFULLY. PLEASE KEEP THIS GUIDE FOR FUTURE REFERENCE RFR-00082 – 1U 24 PORT CONFIGURABLE FIBER SLIDING DRAWER DIRECTION BELOW APPLY SPECIFICALLY TO THE ENCLOSURE Installing adjustable mounting angles (Fig.1) ...
Page 2 OPEN CLOSE Fig.2 Installation of Slack Management Spools (Fig. 3)  Spools are secured using kep nuts  Note: Do not install slack management Spools for Mod link MTP cable and Modular Splice Cassette installations. Fig.3 Back Cable Entry & Retention (Fig. 4) ...
Page 3  Full extension of the drawer is 1 feet.  Molex recommends a minimum of 1 meter of slack be stored inside the enclosure for tight buffered loose tube cables.  Provide minimum 5” to 6” of slack b/w the cable entry point and the point where the cable begins to spool around the slack management spools or Velcro straps.
Page 4 Installing Fiber Adapter Plates (Fig. 6)  Up to four Fiber adapter plates can be installed in the enclosure.  Adapter plates utilize corner retention push pins when pulled upon two corner fasteners.  Position the Fiber adapter plate in the appropriate location within the enclosure and push the two corner fasteners gently back until they will go no further.