hadewe Xantos-BT Manual

Battery drill
Hide thumbs Also See for Xantos-BT:

Advertisement

Quick Links

hadewe GmbH
Grambartstraße 10
30165 Hannover
Germany
info@hadewe.de
www.hadewe.de
Manual
Battery Drill Xantos-BT
(Art. No. 0842)
FB 04-238 Rev. 0
Last revision: 06.12.12
Art. no. 0842

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Xantos-BT and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for hadewe Xantos-BT

  • Page 1 Manual hadewe GmbH Grambartstraße 10 Battery Drill Xantos-BT 30165 Hannover (Art. No. 0842) Germany info@hadewe.de www.hadewe.de FB 04-238 Rev. 0 Last revision: 06.12.12 Art. no. 0842...
  • Page 2: Table Of Contents

    Contents Safety instructions Cleaning & Disinfection Getting to know the unit Before the use Area of application Place of installation Before the first use Maintenance & Care Accumulators Accumulator running time Charging display Charging process Warning LED Warning signal (acoustic) Changing the accumulators Clamping the bur/ tool Adjusting the speed...
  • Page 3: Safety Instructions

    Safety instructions Read this instruction manual in its en- tirety before you start operating the unit. For safety reasons wear goggles during Especially read through any information the treatment. regarding the battery and recharging process to prevent damage to the ac- Ensure that the patient’s foot and the cumulators.
  • Page 4: Cleaning & Disinfection

    For disposal of this unit, please contact We declare under our sole responsibil- the site, where you bought this hadewe case, since that may lead to overheat- ity, that the products 0842, 0842 UK product.
  • Page 5: Getting To Know The Unit

    Bur Shaft Tester (Art. No. jury in case of an unintended start of 4990) to see, if it is bent.
  • Page 6: Before The Use

    A second disadvantage is the • Footcare/Manicure: Milling, trim- board. Any materials used by hadewe pre- stronger impact on the ball bearings ming and polishing . (Attention: vent a formation of rust. In cases in...
  • Page 7 Maintenance & Care Before the use Cleaning the chuck Set the screw spanner (wrench) on 3. Insert the accumulators exactly the axle and hold it tight. Now use as shown below, and make sure 5. Now the right side has to be Because of the additional protection the front of the second spanner to that the cables are stored as...
  • Page 8: Maintenance & Care

    (see Only use charging device, which have “change accumulators”). Attention: been approved by hadewe. Never use For security reasons, only Removed accumulators are still dis- any charging units, which are not explic- change the tool, if the hand- charging themselves.

Table of Contents