Related Manuals for Aqua One MiniReef 215
Summary of Contents for Aqua One MiniReef 215
- Page 1 MiniReef Inspiring Excellence in Fish Care! Instruction version: 14/2/2018 www.aquaone.com.au...
-
Page 2: Important Safeguards
Important Safeguards To guard against injury, basic safety precautions 8. Do not install or store the appliance where it will be should be observed, including the following: exposed to weather or temperatures below freezing. 1. Read and follow all safety instructions and important 9. -
Page 3: Before First Use / Preparation
Use Aqua One Genuine Spare Parts Only. See Your attention is drawn particularly to the sections your local Aqua One Dealer and look for the concerning “IMPORTANT SAFEGUARDS” and the number listed below for the spare part you require. -
Page 4: Cabinet Assembly
Cabinet Assembly Please ensure that all parts are present and undamaged before beginning to build the cabinet. Make sure that Cams are securely locked in place. Centre Support Left Door Base Top Front Right Door Left Side Base Support (x2) Centre Back Right Side Side Back (x2) - Page 5 Step 5 Attach door hinges. Attach the Step 6 Attach magnetic door latches other end of the hinges to side panels and Brackets to Centre Support as shown. Step 7 Place sump in position. Ensure that black foam Step 8 Place and secure Centre Support as shown and mat is positioned under sump for proper support secure with screws on bottom brackets and top screw at top of support .
-
Page 6: Set Up Instructions
Set Up Instructions Please check that all parts and equipment are not use any chemicals or detergents to clean present and not damaged before setting up anything intended for the aquarium. your aquarium. All equipment and accessories should only Refer to the instructions supplied with the be used for the aquarium and should be protein skimmer, heater and return pump for purchased specifically for aquarium use. - Page 7 Set Up Instructions All plumbing components are already glued 2. Place the cabinet on a level surface strong into place except where threaded joints are enough to support the weight of all equipment. required for assembly into the aquarium or Note that water is heavy (1kg per litre).
- Page 8 Set Up Instructions LIGHT INSTALLATION 11. Unpack the supplied filter sock and place it in the location shown on page 6. 1. Loosely attach the supplied brackets to the 12. Ensure the sump is on the far left hand rear of the aquarium cabinet. Do not tighten side of the cabinet so that the drain pipe sits the screws until after the light frame is secured directly over the sump inlet.
- Page 9 3. 2 adhesive rubber pads are supplied. 6. Place the power cables into the cable clip, fold Attach these to the front of the support arms the band over the cable and secure it into place. level with the top of the aquarium. These will protect the glass from contact with the support arms.
-
Page 10: Maintenance
9. Remove the filter sock from the sump and rinse it in water that has been removed from Use quality test kits, Aqua One have a range the aquarium. Replace if necessary. of test kits (sold separately) which will allow you to easily and accurately monitor your 10. -
Page 11: Troubleshooting
Trouble Shooting Specifications BUBBLES ARE COMING OUT THE Aquarium Model: MiniReef 215 OUTLET INTO THE AQUARIUM Overall Dimensions (exc. light): 120 x 45 x 125cm Aquarium Volume: 215L 1. The water level in the sump is too low. Glass Thickness: 8mm... - Page 12 1. all express and implied warranties and conditions under statute or general law, are expressly excluded and Aqua One, where permitted, will limit liability as follows and at Aqua One’s option to: in regard to goods either a) the replacement of goods or supply of equivalent goods b) the repair of goods or the cost of replacing the goods or of acquiring equivalent goods OR in regard to services either c) the re-supply of services d) the cost to re-supply services.
Need help?
Do you have a question about the MiniReef 215 and is the answer not in the manual?
Questions and answers