Download Print this page

Allstar Tear-off machine Installation Instructions

Download this manual

Tear-Off Machine to Shield Installation

Clear Film Housing

(New Film)

Film Guide Lens,

Inner and Outer

NOTE: We recommend installation on a new unscratched shield.

WARNING: Velcro adhesive might not stick properly to older shields due to scratch proof coating peeling off

due to age.

The following instructions are for a new shield with protective film on both sides. If shield does not

have the protective film cover shield with a clear food wrap to protect during installation.

Sit in vehicle with helmet on your head and using a marker place a small mark to identify the

horizotal center point of eyes. This is the comfortable height at which you will look out of the shield

while sitting in the race car seat. Transfer marks to the backside of shield also for later use.

Remove shield from helmet, then remove pegs that hold manual tear offs if applicable.

Mark the vertical centerline of shield using tape measure. This is the center from right to left. Transfer

these marks to the backside of shield for later use.

Using a pinch type clamp, clamp the tear-off machine to the center point of your shield. Make sure

protective material is used to prevent damage to the shield or tear-off machine.

By hand, hold each end of guiding system tight to shield and verify that the 2 outside quick release

mounting points are within the shield.

Allstar Performance 8300 Lane Dr., Watervliet, MI 49098

Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com

Form 1174

INSTALLATION INSTRUCTIONS

Mud Scraper

Page 1 of 4

Tear-Off Machine

Rev. 050219

Black Aluminum Film

Housing (Used Film)

Page 1 Using a pinch type clamp, clamp the tear-off machine to the center point of your shield. Make sure protective material is used to prevent damage to the shield or tear-off machine.
Page 2 While unit is clamped to shield mark the backside of the shield with a marker to show the inside and outside edge of the Velcro located on the tear-off machine. Marking the inside and outside will help with placement of the Velcro strips that are installed in Step 13.
Page 3 Route the vehicle harness starting with the plug-in end located close to the driver seat. Verify the plug is located at a convenient location for connecting to the Tear-Off Machine with the driver in the driver’s seat.
Page 4 Tip: Put a 2” long strip of electric tape over (2) vertical forward facing screws on scraper to keep mud out of screw heads. Allstar Performance 8300 Lane Dr., Watervliet, MI 49098 Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com Form 1174 Page 4 of 4 Rev.