Florence MyPackageConcierge Installation Manual

Advertisement

Quick Links

INSTALLATION GUIDE

Advertisement

Table of Contents
loading

Summary of Contents for Florence MyPackageConcierge

  • Page 1 INSTALLATION GUIDE...
  • Page 2: Table Of Contents

    © 2019 Florence Corporation. All rights reserved. TABLE OF CONTENTS Supporting Technical Documents Getting To Know Your MyPackageConcierge® What’s Inside? Tools Required Prepare your MyPackageConcierge® for Installation Preparing For and Installing Your MyPackageConcierge® Rough Opening Verification Prepare The Opening Setting And Fastening Your MypackageConcierge®...
  • Page 3: Getting To Know Your Mypackageconcierge

    Getting To Know Your MyPackageConcierge® What’s Inside? The following items are included with your MyPackageConcierge® package box: ` Installation Guide ` Owner’s Guide—please retain this guide for the new Homeowner ` Mounting Hardware K64225 - #8 x 2” pan-head T20 Torx wood screw (qty 23) Tools Required Tools necessary to install the MyPackageConcierge®...
  • Page 4: Preparing For And Installing Your Mypackageconcierge

    16-1/2” in width. 2). Fix any problems with the rough opening before proceeding. Prepare The Opening Install a Water Resistive Barrier (WRB) prior to installation of the MyPackageConcierge® and seal around the rough opening using standard practices. • Under extreme wind/water exposure, incidental water that migrates behind the WRB due to penetrations, fasteners, or cladding attachment may migrate into the package box rough opening.
  • Page 5 • As an option, the sealant can be applied to the wall surface, as opposed to the back of the integrated trim. Immediately place MyPackageConcierge® in the wall opening until the integrated trim is flush against the wall board. •...
  • Page 6: Install Interior Sealant

    Fiberglass batt or similar insulation is not recommended as it can absorb water and does not act as an air seal. NOTE: Use a low odor, paintable sealant. Re-check MyPackageConcierge® operation after foam installation. Excess foam may be removed with a serrated knife after it cures.
  • Page 7: Important Product Information

    Buyer or User, the architect, contractor, installer, or other construction professional and are not the responsibility of Florence Corporation. ` Florence products should not be used in barrier wall systems which do not allow for proper management of moisture within the wall systems, such as barrier Exterior Insulation and Finish Systems (EIFS) (also known as synthetic stucco) or other non-water managed systems.
  • Page 8 www.MyPackageConcierge.com...

Table of Contents