Advertisement
A rain gutter is an ideal location for the RainSensor. Simply position
the bracket with the thumbscrew under the gutter lip and tighten to
secure (do not over-tighten). See Figure 4 below.
Figure 4
The RainSensor can also be mounted on any suitable solid struc-
ture such as the side of the roof, a shed or fence using the two sup-
plied stainless steel screws. See Figure 5 below.
Figure 5
Once securely fastened, adjust the RainSensor on the mounting
bracket as needed to align the RainSensor housing vertically.
Routing the RainSensor Control Wire
Route the RainSensor control wire back to the controller. Avoid run-
ning the wire over sharp edges where cutting or abrasion of the
wire insulation may occur. For best results, hide the wire where
possible by it tucking it under shingles and/or moldings. Seal any
holes made by passing the wire through structure walls.
Thumbscrew
To Controller
Rain gutter
(cross section view)
Stainless
Steel
Screws
To Controller
Advertisement
