Table of Contents
Advertisement
Quick Links
Wireless timer control with 16 programmable channels to control individual receivers on daily basis
at a pre-programmed time and up to maximum of 12 times a day.
Display Information
1.
Memory slots. (Max. 12)
2.
24 hour time display
Displays 'ON' timer for indicated unit.
3.
Displays 'OFF' timer for indicated unit.
4.
Timer setting: Random 'ON/OFF' mode
5.
for security prevention.
Timer setting: Single 'ON/OFF' mode.
6.
Timer setting: 'ON/OFF' daily cycle mode.
7.
8.
Battery Status.
9.
Unit.
10. Signal indication.
11. ON / OFF' button.
12. 'UP ▲/ DOWN▼' selection.
13. 'Pause / Delete' button.
14. 'Enter' button.
15. Clock.
16. Timer.
17. Unit code selection.
Wireless Timer Control
Advertisement
Table of Contents
Summary of Contents for Kappa TMT-918
- Page 1 Wireless Timer Control Wireless timer control with 16 programmable channels to control individual receivers on daily basis at a pre-programmed time and up to maximum of 12 times a day. Display Information Memory slots. (Max. 12) 24 hour time display Displays ‘ON’...
- Page 2 Set up clock The clock has a 24 hour display. Before programming the control, enter the correct time. Press the CLOCK button for 3 seconds and the hours of the clock start flashing (Fig.1) Use the ▲ and ▼ buttons to set the hour and press ENTER (Fig.2) ...
- Page 3 Then on timer control press ‘OFF’ button once, the LED on receiver will flash to indicate programmed code is deleted. To delete all code: On receiver hold down the self learning button on receiver for 6 seconds, this will enter learning / deleting mode.
- Page 4 will start to flash. (Fig.13) With ▲ and ▼ select one of the three symbols you wish to program as. Daily timer. Once only timer. Random timer.
- Page 5 Press ‘TIMER’ to return to Main Display. ！ You can reprogram a timer simply by over lapping the memory slots. ※Hint※ During any setting, press the ‘TIMER’ button to exit out and restart your settings again. Pausing a Timer The ‘II / DEL’...
- Page 6 Child protect mode To avoid your settings being changed, a child protect mode has been built-in. The timer control will be locked and LCD screen will indicate ‘CP’ Activating CP mode Hold down both ‘ENTER’ & ‘II / DEL’ button for 3 seconds. (Fig.17) ...
- Page 7 Trouble Shooting Text on display is unclear. Press ‘TIMER’ button for 3 seconds. If there is no text or remains unclear, change the lithium battery 3V CR2032. No red RF signal indicator. Check the 12V A23 battery and replace if required. Specifications.
Need help?
Do you have a question about the TMT-918 and is the answer not in the manual?
Questions and answers