Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for PERGO SCHWAMMFIX POWER SPONGE 620P
- Page 1 PERGO 620P SCHWAMMFIX POWER SPONGE User & Safety Instructions...
- Page 2 SAFETY INSTRUCTIONS Conform to material or grout manufacturers recommended work methods and instructions; observe COSHH recommendations Turn off machine before changing the sponge, undertaking any maintenance or cleaning Wear dust masks, gloves and protective clothing if recommended by the material manufacturer Wear ear defenders Hold machine firmly with both hands whilst in use Do not put hands near sponge or water tub when in use...
- Page 3 The machines use a continuous sponge band that is fed through a water bucket and rollers; the excess sludge and water is squeezed out leaving the sponge clean to repeat the cycle Finishing rates up to 100m²/hr. CHANGING THE WATER BUCKET Lift water container off bracket J and lower Flip bracket J back to allow clearance Lift machine up...
- Page 4 ADJUSTMENT Once a new sponge has been fitted it will need to be aligned . Start machine on slow revs. This will allow sponge to centralise. If the sponge runs to the left or right it will need to be adjusted to do this. Stop Engine Loosen lock nut D Next slacken adjustment handle B...
- Page 5 The machine is designed to be used from left to right. Start the job on the left side and move stroke by stroke to the right to enhance the machine’s performance Run the sponge belt several rounds through the water buckets to ensure water saturation of the sponge belt Move machine diagonally to grout joints in long strokes, 6 to 8 feet, go from left to right Forward motion pre-cleans and backward motion is the main clean.
Need help?
Do you have a question about the SCHWAMMFIX POWER SPONGE 620P and is the answer not in the manual?
Questions and answers