FIBRO F-16 Instructions Manual

It is important to follow these instructions to ensure the pool's proper functioning and
durability.
Basic rule: NEVER EMPTY YOUR POOL
because of the possible water pressure under the pool. If not, the warranty will no longer
be in effect.
The water level in the draining well must be checked before reducing the water level in
the pool. The draining well must always be at least 2 feet (66 cm) lower than the water
level in the pool. It is important to consider in the calculations the decrease in the pool's
water level (5 inches (13cm) below the opening of the skimmer) for the closing as
illustrated below. There must always be more water in the pool than in the groundwater;
this principle is valid for concrete or vinyl swimming pools.
Important: Should the forecast predict heavy rain, it is important to check the water level
level in your draining well before, during and after. The water level in your well should be
lower than the one in your pool. If necessary, empty out the well using a submersive pump.
It is normal for the pool's water to be high. Best be too high than too low.

Necessary items:

•
Mop
•
Vaccuum cleaner that blows and sucks air (Shop Vac)
or compressor
•
Winterizing kit (supplied at the time of purchase)
•
8 litres of biodegradable antifreeze
•
Right-handed screwdriver
•
Leaf net (needed to facilitate the pool's opening.
Without this net, the leaves settle to the bottom and may
stain the swimming pool).
WINTERIZING
A F-16 MODEL
FIBRO POOL
Sand or glass system
without the manufacturer's authorization,
draining well 5" pcs (13 cm)
Kit
Fall net
Winter tarp