Artel DLT710 Quick Start Manuals

REAR PANEL
SWITCH LOCATION
SW1
SW2
Configuration Switch Functions
SW1 Determines a portion of the test
timing and enables test features
SW2 Determines signal format, input
source, and EMS functionality
Rear
Determines test pattern type, signal
Panel
type, test mode (continuous or single
Switch pass), and length of test
QUICK START GUIDES
DigiLink DLT710 - Multi-Format Digital Video
Generator and Test Module
Artel ships the DLT710 configured as follows:
• All signal types enabled (3G, HD, SD, DVB-ASI, ATSC)
• Electrical input set to BNC
• Front panel GEN/CHK switch set to CHK
• LEDS indicate checker status
• Monitor jack contains copy of input BNC
• Multi-format, continuous test mode enabled
• Signal check test interval set to 60 seconds
• Signal check synchronization interval set to 5 seconds
• SDI generator pattern set to color bars, full screen @ 75%
• 1080p 59.94 frames/sec
• 1080i 29.97 frames/sec
• 525i 29.97 frames/sec
• Embedded audio is 1 kHz tone @ -20 dBfs, all 4 channels of audio group 1
• DVB-ASI and ATSC generator transport stream
• SMPTE color bars with moving block
• MPEG-2 single program @ 19.292 Mb/s
• SD video format, 720x480i, 29.97 fps
• Embedded audio is left/right channel, 1 kHz tone @ -20 dBfs, AC-3 format
• Report data rate frequency errors > 40 ppm
• Report inverted DVB-ASI format
• EMS override is allowed (DigiLink Manager can change the DLT710 configuration)

DIP SWITCH CONFIGURATIONS

Rear Panel Switches

SW Function Off (Down)
S1 SDI Pattern Pathological
3G-SDI
S2 Disabled
S3 HD-SDI Disabled
S4 SD-SDI Disabled
S5 ASI Disabled
ATSC
S6 Disabled
Check Single-Pass
S7
Mode Test
Signal Test
S8 Custom
Interval
Factory Default: All On
Monitor Mode: All Off (See User Manual for Details)

SW1 Configuration

SW Function off
S1 Reserved -
S2 Reserved -
S3 Reserved -
Reserved
S4 -
S5 Reserved -
S6 ASI INV Test Disabled
S7 Freq Test Disabled
Sync Interval
S8 Custom
Factory Default: All On

SW2 Configuration

On (Up) SW Function
Color Bars S1 HD Vert Res
Enabled
Enabled
S2 Format
Enabled
Enabled
Reserved
S3
Enabled
S4 Reserved
Continuous
Factory Default: All On
Test
S5 S6 S7
Normal
On On On
Off Off Off
Off On Off
Off Off On
Off On On
On
Factory Default: All On
Default
Default SW Function
Default
EMS
S8
Override
Default
Factory Default: All On
Default
Enabled
Enabled
Normal
Off On
720p 1080i
525 Line
625 Line
(SD) 59.94
(SD) 50
Field Field
(HD/3G) (HD/3G)
Default
-
- Default
Checker Input
BNC In
Backplane 1
Backplane 2
Backplane 3
Backplane 4
Off On
Local Remote
41