Table of Contents
Advertisement
Quick Links
I.
CONTACTS
II.
ORIGINAL INSTRUCTION MANUAL
III.
WARRANTY TERMS AND CONDITIONS
IV.
UNIT STARTUP REPORT
V.
INSPECTION AND MAINTENANCE DOCUMENT
VI.
SERVICE NOTIFICATION
VII. LIST OF SUBASSEMBLIES INSTALLED IN THE UNIT
Please read this instruction manual carefully before beginning any work.
Szymański, Nowakowski General Partnership
phone +48 81 883 56 00, fax +48 81 883 56 09
TROPIC
HEATING UNIT
RYKI 2013
ISSUE 1 EN
31 Lubelska Str., 08-500 Ryki
POLAND
Advertisement
Table of Contents
Summary of Contents for Juwent TROPIC-1
- Page 1 Szymański, Nowakowski General Partnership 31 Lubelska Str., 08-500 Ryki phone +48 81 883 56 00, fax +48 81 883 56 09 POLAND TROPIC HEATING UNIT CONTACTS ORIGINAL INSTRUCTION MANUAL III. WARRANTY TERMS AND CONDITIONS UNIT STARTUP REPORT INSPECTION AND MAINTENANCE DOCUMENT SERVICE NOTIFICATION VII.
- Page 2 I. CONTACTS Szymański, Nowakowski General Partnership 31 Lubelska Str., 08-500 Ryki phone +48 81 883 56 00, fax +48 81 883 56 09 POLAND Export department mob.+48 502 087 841 mob.+48 664 465 243 export@juwent.com.pl www.juwent.com.pl...
- Page 3 II. ORIGINAL INSTRUCTION MANUAL TROPIC HEATING UNITS Size 1, 2 www.juwent.com.pl...
-
Page 4: Table Of Contents
1. INTENDED USE 2. DESIGNATIONS 3. DEVICE DESCRIPTION 4. TECHNICAL DATA 5. TRANSPORT 6. SAFETY RECOMMENDATIONS 7. MOUNTING 8. WATER INSTALLATION 9. ELECTRICAL INSTALLATION 10. AUTOMATICS 11. DEVICE STARTUP 12. REPAIR, MAINTENANCE AND WITHDRAWAL FROM SERVICE 13. TROUBLESHOOTING 14. INFORMATION www.juwent.com.pl... -
Page 5: Intended Use
There is a risk of heating medium freeze in the heater in the compartments with the temperature below 0 The risk can be reduced using an antifreeze thermostat (delivered at request), using antifreeze heating media or removing water from the unit. www.juwent.com.pl... -
Page 6: Technical Data
4. TECHNICAL DATA Unit size TROPIC-1 TROPIC-1 Dimensions A[mm] B[mm] L[mm] 1/2” 3/4” Weight (I-row exchanger) [kg] Weight (II-row 33,5 exchanger) [kg] Parameters of fans in units Voltage [V] Motor power [kW] 0,13 0,61 Current [A] 0,59 Revolutions [rpm] 1400... -
Page 7: Safety Recommendations
Therefore there is a residual risk when the operator does not observe the recommendations and guidelines included in the instruction manual. www.juwent.com.pl... -
Page 8: Mounting
The units can be hung on the wall or suspended to the ceiling. A mounting console is used to install the unit on the wall. The length of the bolts fastening the unit to the console – max. 20mm. TROPIC-1 Side view Top view... -
Page 9: Water Installation
A minimal distance of the unit to the wall or ceiling necessary to ensure a free air supply to the fan is: 18cm for TROPIC-1 units, 25cm for TROPIC-2 units When it is necessary to hang the unit on a partition, e.g. made of steel sheets, stiffening profiles should be used to avoid vibrations of the partition generated by the unit operation and the noise level increase in the compartment. -
Page 10: Electrical Installation
U1 - brown PW – Switch-off control button U2 - blue B1,B2 – Fuses Z1 - black PE – Protective terminal Z2 - orange Tk – Thermal protection Tk - white Fig. 1. TROPIC unit connection and control diagram www.juwent.com.pl... -
Page 11: Automatics
Measurement 8...+30 8...+35 range Contact rating 6(2)A 10(1,5)A L-Y1 Heating Protection L-Y2 Cooling IP30 IP65 rating Thermostat with time programmer TPP Supply voltage 2 batteries 1,5V Measurement range 5...+35 Contact rating 5(2)A Q11-Q14 Heating Q11-Q12 Cooling Protection rating IP30 www.juwent.com.pl... - Page 12 V20 (on/off) are used. The valves should be installed in the supply line, the flow is admissible only in the marked direction AB->A or AB->B. Symbol Unit type Tropic-1 1...110 Tropic-2 FITTINGS: Z: cut-off valve: manual...
- Page 13 Exemplary connection and control electric diagrams of the TROPIC units Fig. 2. Electric connection diagram without automatics Fig. 3. Electric connection diagram with revolution controller Fig. 4. Electric connection diagram with automatics (revolution controller, valve servomotor and fan operation are controlled by thermostat) www.juwent.com.pl...
-
Page 14: Device Startup
» switch off the current supply to the electric motor of the fan. In case of long standstills of the unit or breaks of heating network operation the heater should be drained and the cut-off valves should be closed, if need be. www.juwent.com.pl... -
Page 15: Repair, Maintenance And Withdrawal From Service
The excessive heater contamination reduces the heating power and air efficiency of the unit. After withdrawal from service the unit should be passed over to the specialized collection point of recyclable materials. www.juwent.com.pl... -
Page 16: Troubleshooting
4) if there is no characteristic “tick”, the thermostat is me- chanically damaged and should be claimed. 14. INFORMATION As to all issues concerning the TROPIC heating units please contact JUWENT Production Plant or Representatives www.juwent.com.pl... - Page 17 III. WARRANTY TERMS AND CONDITIONS JUWENT Szymański, Nowakowski General Partnership, headquartered in Ryki at 31 Lubelska Str., hereinafter referred to as the Warrantor, grants the Customer a warranty of proper operation of the unit with reservation of the requirement of its use in accordance with the conditions determined in the instruction manual and the terms and conditions specified below.
- Page 18 / name and signature V. INSPECTION AND MAINTENANCE DOCUMENT Date of Executor of inspection Service activity range Remarks inspection stamp / name and signature * Inspection of the unit in accordance with the section “Repair and Maintenance” in the instruction manual www.juwent.com.pl...
- Page 19 NOTE: AFTER COPYING AND FILLING IN SEND THE NOTIFICATION BY FAX OR EMAIL TOGETHER WITH A COPY OF THE STARTUP REPORT. JUWENT Company accepts notifications filled legibly and completely. When the lodged claim is not justified, the claimer will be burdened with service costs.
- Page 20 VII. LIST OF SUBASSEMBLIES INSTALLED IN THE UNIT Name of subassembly Axial fan with single-phase motor Metal louvre I-row heat exchanger Metal louvre II-row heat exchanger *) - mark proper box corresponding with the equipment variant...
Need help?
Do you have a question about the TROPIC-1 and is the answer not in the manual?
Questions and answers