Advertisement
Quick Links
Advertisement
Summary of Contents for NCR 7403-K171
- Page 1 7403-K171 Integrated CD/DVD ROM Kit Instructions Issue A...
-
Page 3: Revision Record
Revision Record Issue Date Remarks Nov 2008 First issue... - Page 5 Introduction This kit adds an Integrated CD/DVD-ROM Drive to the 7403.
-
Page 6: Installation Procedures
Installation Procedures Caution: Static Electricity Discharge may permanently damage your system. Discharge any static electricity build up in your body by touching your computer’s case for a few seconds. Avoid any contact with internal parts and handle cards only by their external edges. 1. - Page 7 c. Pivot the top of the Front Base Cover toward the front of the unit and remove it from the terminal. 26032 d. Disconnect the Power Cord from the Power Supply. AC Power Cord 26135...
- Page 8 2. Remove the Cable Clamp. This clamp is not used when the DVD is present. Loosen the thumbscrew and remove the screw on the opposite end of the clamp. Cable Clamp 26461 3. Carefully position the terminal on its back. 4.
- Page 9 5. Connect the CD/DVD Power and SATA Cables to the DVD Drive. 6. Secure the cables to the CD/DVD Bracket using a tie wrap. 7. Fold the cables as shown below. Route the Power Cable as shown to keep it out from under the sheet metal when installing the drive.
- Page 10 8. Connect the CD/DVD Power and SATA Cables to the 7403 Backplane Board. CD/DVD Power Cable SATA Cable 26465 9. Install the CD/DVD Assembly. a. Align the tabs (4) on the edge of the DVD Bracket above the slots in the 7403 Base.
- Page 11 10. Secure the assembly with the DVD Bracket Thumbscrew. Pivoting Extensions DVD Bracket Thumbscrew Cable Tie Wrap Anchor Points 26147a 11. Route the external cables in the channel(s) and pivot the extensions to keep the cables secure. Secure the cables to the Base using Tie Wraps as necessary.