Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Lakes COASTLINE ONE DOOR QUADRANT ENCLOSURE
Summary of Contents for Lakes COASTLINE ONE DOOR QUADRANT ENCLOSURE
- Page 1 COASTLINE ONE DOOR QUADRANT ENCLOSURE Installation / Maintenance Instructions Rev 05.12 Rev 01.19...
-
Page 2: Important Notes
However should maintenance be required it should be carried out by a competent person with reference to these instructions. Before any work is carried out the root cause of the problem must be identified. Lakes Bathrooms service engineers are available if necessary to consult / carry out remedial work. Call Lakes Bathrooms HELPLINE. - Page 3 SUPPLIED PARTS : Fixed Panel Sub Assy 1x flat : 1x curve Curved Horizontal Profile (handed pair) complete with glass Glazing Blocks pair each vertical frame Doorstop blocks & Buffers 4 each Stiffener (frame corners) 3,5 x 10 pan head self tapping screws Cover Caps 3,5 x 40mm...
- Page 4 Tape Measure Spirit Level (with vertical ‘bubble’) Lakes Coastline Quadrant is fully reversible, so suitable for fitting to left or right hand trays. Ensure tray is correctly levelled & that all tray/wall joints are sealed & cured over entire length of tray sides (See Fig A ) prior to fitting enclosure.
- Page 5 FRAME SUB ASSEMBLY (glazing blocks / doorstops pre fitted—shown for reference only) Glazed Corners. Assemble glazing seals onto glass end as shown. Check glazing block location around glass corner before fully tightening corner screws (2 per corner). pilot hole glazing block/glass Doorstops Glazing...
- Page 6 PLUMB, & AFFIX FRAME Manipulate & centralise frame in wall mounts until plumb (check vertical &horizontal frame members). Check that frame is parallel to tray edges & curve. With frame in desired position, from inside enclosure, using wall profile holes as a guide, drill dia 3mm pilot holes &...
- Page 7 DOOR ASSEMBLY Top Wheel : Assemble with adjusting screw to underside. Right hand shown. Lightly tighten clamp screw (reverse for Left hand) & do not fit cover** at this stage. Assemble handle to glass as shown (grubscrews to inside). Ensure plastic washers are fitted each side beneath handles.
- Page 8 HANG DOORS Carefully lift doors into enclosure & engage top wheels into wheel groove. (If necessary loosen, but do not remove centre screw to permit engagement). Immediately after all wheels are correctly engaged, fully tighten centre screw to retain door. Fit internal wheel covers **.
- Page 9 FIT EDGE & MAGNETIC SEALS Fit edge seals to leading edges of fixed panels & trailing edges of doors. Fit magnetic seals to leading edges of doors as shown. SEALS MAY BE WETTED TO EASE ASSEMBLY...
- Page 10 ADJUST DOORS & SEALING From underside of top wheels, adjust door height until bottom wheels are engaged in horizontal profile (no wobble). Then adjust door angle plumb with vertical frame profiles & check door magnets in contact over full door height. Use of good quality silicone sealant &...
-
Page 11: Basic Troubleshooting
In the unlikely event of an enclosure leak, water will be visible on the outside of the enclosure itself, or around the perimeter joints ONLY. Water / moisture appearing outside this area (ie at floor level) is normally due to incorrect tray installation. Service : Northern Ireland Lakes Bathrooms Ltd Ian A Kernohan Alexandra Way Firtrees...
Need help?
Do you have a question about the COASTLINE ONE DOOR QUADRANT ENCLOSURE and is the answer not in the manual?
Questions and answers