EUROPEAN FINISHING EQUIPMENT MODEL PND-2500A Manual

E F
UROPEAN INISHING
901Penhorn Ave, Unit #2
Secaucus, NJ 07094
Tel: (201) 210-2247 (888) 460-9292 Fax (201) 210-2549
www.histeam.com
1. RISK OF FIRE – Turn off the vacuum board and iron switches, and unplug the vacuum
board and iron when finished ironing.
2. To avoid a circuit overload, do not operate another high voltage appliance on the same
circuit.
1. Use vacuum board only for its intended use.
2. To protect against a risk of electric shock, do not immerse the vacuum board in water
or other liquids.
3. The vacuum board should always be turned "Off" before plugging or unplugging from
outlet. Never yank cord to disconnect from outlet; instead, grasp plug and pull to
disconnect.
4. Do not allow cord to touch hot surfaces. Let vacuum board and iron cool completely
before putting away.
5. Always disconnect appliance from electrical outlet when not in use.
6. Do not operate appliance with damaged cord or hose, or if the appliance has been
damaged.
To reduce the risk of electric shock, do not disassemble or attempt to repair the
appliance. Take it to a qualified service person for examination and repair. Incorrect re-
assembly or repair could cause a risk of fire, electric shock, or injury to persons when
the appliance is used.
7. Close supervision is necessary for any appliance being used by or near children. Do not
leave appliance unattended while connected or while iron is on vacuum board.
8. Burns could occur from touching hot metal parts, hot water or steam.
E
QUIPMENT
sales@histeam.com

IMPORTANT SAFETY INSTRUCTIONS

MODEL PND-2500A
FOR COMMERCIAL USE ONLY
READ ALL INSTRUCTIONS BEFORE USING

SPECIAL SAFETY INSTRUCTIONS

-------------------------------

GENERAL SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS
C .
ORP
1
7/20/15