Kia Niro 2017 Owner's Manual page 269

Audio system
✽ ✽ NOTICE -
Using the iPod
Devices
• To use the audio system's iPod
control function, use the dedicated
cable provided with your iPod
®
• Connecting the iPod
cle during play may result in a
loud noise that lasts about one to
two seconds. Connect the iPod
the vehicle after stopping or paus-
ing play.
®
• Connect the iPod with the vehicle
in the ACC ON state to begin
charging.
• When connecting the iPod
be sure to fully push the cable into
the port.
• When EQ effects are enabled
simultaneously on
devices, such as iPod
audio system, the EQ effects may
overlap, causing sound quality
deterioration or
Deactivate the EQ function for all
external devices, if possible.
• Noise may occur when your iPod
or the AUX port is connected.
Disconnect and store separately
when not in use.
5 16
(Continued)
®
• There may be noise if the audio
system is used with an iPod
®
AUX external device connected to
the power jack. In these cases, dis-
®
.
connect the iPod
to the vehi-
device from the power jack.
• Play may be interrupted, or device
malfunctions may occur depend-
® to
ing on the characteristics of your
®
iPod /iPhone
• Play may fail if your iPhone
connected
Bluetooth
and USB. In this case, select Dock
®
cable,
connector or Bluetooth
Technology on your iPhone
change the sound output settings.
• If your software version does not
external
support the communication proto-
®
s and the
col or your iPod
due to device failure, anomalies or
defects, iPod
distortion.
used.
®
• iPod
devices may not be recognized if
®
the battery is low. Charge suffi-
ciently before use.
(Continued)
®
or
®
or external
®
.
®
is
through both
®
Wireless Technology
®
Wireless
®
to
® is not recognized
® mode cannot be
nano (5th generation)
(Continued)
(Continued)
• The search and song play order in
®
the iPod device may be different
from the search order in the audio
system.
®
• If the iPod has failed due to an
internal defect, please reset the
®
iPod (consult your iPod
• Depending on the software ver-
®
sion, the iPod may fail to sync
with the system. If the media is
removed or disconnected before
recognition, the previous mode
may not be restored (iPad
be charged).
• Cables other than the 1-meter
cable provided with iPod
products may not be recognized.
• When other music apps are used
on your iPod ® , the system sync
function may fail due to malfunc-
tion of the iPod ® application.
®
manual).
®
cannot
® ®
/iPhone