Huawei S2700 Product Documentation page 9

HEEX Startpage
S2700-52P-
PWR-EI
S2710-52P-
PWR-SI
1. AC jack
5. Eight 10/100BASE-TX
Ethernet electrical interfaces
9. One 1000M combo
interface
(10/100/1000BASE-
T+100/1000BASE-X)
13. Two 100/1000BASE-X
Ethernet optical interfaces
NOTE:
By default, a combo port works in auto mode, in which the port type is determined as follows:
If the optical port has no optical module installed and the electrical port has no network cable connected, the port type depends on
which port is connected first. If the electrical port is connected by a network cable first, the electrical port is used for data switching.
If the optical port has an optical module installed first, the optical port is used for data switching.
If the electrical port has a network cable connected and is in Up state, the electrical port is still used for data switching when the
optical port has an optical module installed.
If the optical port, no matter in Up or Down state, has an optical module installed, the optical port is still used for data switching
when the electrical port has a network cable connected.
If the optical port has an optical module installed and the electrical port has a network cable connected, the optical port is used for
data switching after the switch restarts.
You can configure a combo port as an electrical or optical port using the combo-port command.
shows the rear views of S2700.
Table 2
Table 2 S2700 rear views
Model Image
S2700-9TP-SI-
AC
S2700-9TP-EI-
AC
S2700-9TP-EI-
DC
S2700-9TP-
PWR-EI
http://localhost:7890/printtopics.html?time=Thu Dec 10 16:53:17 UTC-0200 2015
2. DC terminal 3. Switch
6. Sixteen 10/100BASE-TX 7. Twenty-four 10/100BASE-
Ethernet electrical interfaces TX Ethernet electrical
interfaces
10. Two 1000M combo 11. One console interface
interfaces
(10/100/1000BASE-
T+100/1000BASE-X)
Page 9 of 34
4. Ground screw
8. Forty-eight
10/100BASE-TX
Ethernet electrical
interfaces
12. Two 1000BASE-X
Ethernet optical interfaces
12/10/2015