Page 1
OPERATING AND SETUP INSTRUCTIONS Introduction The Rickard Wall Stat provides the user with an interface to control the set point of the environment it is installed in as well as monitor the current temperature. Using the MLM software, further functions can be enabled but are not covered in this manual. Please refer to the Extended Rickard Wall Stat Manual (INST-RICKWSE) for further information.
Page 2
Display Description Function Degrees Celsius Control Degrees Fahrenheit Control Function Display Control/General Main Display Litre per second Air volume Cubic feet per min Air volume Battery Low Diagnostics Setup Commissioning Set point Control Cooling mode Control Heating mode Control Real time clock Back-off timer Wireless connect Connection...
Page 3
Start Up On power up or if a reset command from the MLM application is being executed, the display will initially indicate the WS firmware revision number, with the function characters indicating Ur. The display shown here indicates version 2.05. After a few seconds the display will revert to the default temperature display and the diffuser will enter the initialization mode.
Page 4
Function Select button to exit this function and advance to the next display. Further Information As previously mentioned further menu functions are available if activated using the MLM software. If these appear please refer to the Extended Rickard Wall Stat Manual for further information. Part No.: INST-RICKWS 08/12...